6G Celicas Forums

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> transmission problem
post Aug 31, 2012 - 2:41 PM
+Quote Post
1000_needles

Enthusiast

Joined Aug 31, '12
From canada
Currently Offline

Reputation: 0 (0%)




i have the e153 lsd transmission whit the hybrid axles setup,
after changing my clutch for a new one, i did forgot to put back the nuts that hold the bracket that hold the right side axle in place, (the 2 bolt in middle axle that hold on the engine ) after a 200 km ride , i notice a weird noise ,
and when i push gas hard it spinning free in the trans, the car can move but, at 50 km/h i get a noise like very loud from the tranny. (the shaft was loose and moved to front and back into tranny )

can someone suggest what it can be ?

maybe i damage the shaft from axle inside,

or

does the gear in the transmission get damage ?

thanks

This post has been edited by 1000_needles: Aug 31, 2012 - 2:43 PM
post Aug 31, 2012 - 3:42 PM
+Quote Post
jordisonjr



Enthusiast
*****
Joined Jan 20, '09
From Winnipeg
Currently Offline

Reputation: 5 (100%)




You most likely damaged something, I'm going to say the axle, but could be wrong.
Now you'll remember to bolt it up next time laugh.gif


--------------------
-Protection mode, For when your amp tries to blow its load.

1995 Toyota Celica GTS - Daily Driver
1999 Chevy Cavalier - Winter Beater
1994 Honda Civic CX Hatchback - Dead

My Celica!
post Sep 1, 2012 - 9:40 AM
+Quote Post
ILoveMySilly97



Enthusiast
*****
Joined Mar 8, '12
From Hanford/Fresno, Ca
Currently Offline

Reputation: 20 (100%)




Man that front passenger axle was a pain in the ass to replace. Removing the bracket was the hardest part. I remember I was going to just not bolt it like what you did too but good thing I forced myself to find a way to remove the bracket from the old one and put it on the new axle. Lol.


--------------------
post Sep 1, 2012 - 1:04 PM
+Quote Post
Special_Edy



Enthusiast
****
Joined Oct 29, '11
From Haltom City, Texas
Currently Offline

Reputation: 1 (100%)




He has a camry or turbo mr2 transmission though.

I know you already know to do this but remove the axle and check the splines on it for damage. Worst case scenario is that you screwed up the differential on the transmission though it can probably be replaced without removing the transmission. Also a good time to upgrade to LSD
post Sep 1, 2012 - 9:51 PM
+Quote Post
1000_needles

Enthusiast

Joined Aug 31, '12
From canada
Currently Offline

Reputation: 0 (0%)




QUOTE (Special_Edy @ Sep 1, 2012 - 2:04 PM) *
He has a camry or turbo mr2 transmission though.

I know you already know to do this but remove the axle and check the splines on it for damage. Worst case scenario is that you screwed up the differential on the transmission though it can probably be replaced without removing the transmission. Also a good time to upgrade to LSD


lol its already lsd, but i just find a new mr2 turbo 1990 for 250 $, non lsd,
i dont know what to do really, ill maybe just gonna buy that tranny and put it there, but i will check the differential into transmission before,

the right wheel does 1/4 of turn loose (the shaft move, but freely for 1/4 of turn)
the left side dont, no loose there
post Sep 1, 2012 - 10:11 PM
+Quote Post
Special_Edy



Enthusiast
****
Joined Oct 29, '11
From Haltom City, Texas
Currently Offline

Reputation: 1 (100%)




pull the axleshaft out and examine the splines where it attaches to the tranny. Im willing to bet your axle slide out far enough that the splines wernt engaged and they just rubbed inside the differential. Im not sure that your LSD would survive being driven with only one axle or if it would burn up.
post Sep 2, 2012 - 3:07 PM
+Quote Post
1000_needles

Enthusiast

Joined Aug 31, '12
From canada
Currently Offline

Reputation: 0 (0%)




QUOTE (Special_Edy @ Sep 1, 2012 - 10:11 PM) *
pull the axleshaft out and examine the splines where it attaches to the tranny. Im willing to bet your axle slide out far enough that the splines wernt engaged and they just rubbed inside the differential. Im not sure that your LSD would survive being driven with only one axle or if it would burn up.


i had put back the bolt in the bracket but problem persist and the axle did not slide out,
i think the lsd is burned

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: March 28th, 2024 - 10:40 AM