So I know there's already a post your slammed thread out there, but how many of us are REALLY STANCED? Are there other guys or girls on here slamming there celi's, or poking and stretching their tires. I was fortunate enough to live in Japan for four years and actually watch this trend develop from the K-cars to the drifters, the cholo honda accords on the tiny spoked daytons(yes I said and they were pretty nicly built), to your everyday DD they were out there. Granted this trend has been round for years but recently in the late 07' is when it really started to grow. Never did I expect it to grow this large. And Im falling in love with it more and more which has me deciding to take my project in that direction. With a decent drop on my megans, some new 18s, and low profile streched tires.

Again is there any members that are STANCED? Also what is everyone elses opinion on this trend.

http://youtu.be/T7JNZboSuRk
http://youtu.be/V-V3kilkeaM
http://youtu.be/QGj9qX6_9GQ

http://www.stancenation.com/

I'm stretched and stanced but not slammed. This is my lowest without the ugly uber negative camber.

My setup is

Advan SA3 17x8 +38F & 17x9 +31R. Got 15mm spacers all around. Lowered on Megan Racing Coilovers. Rear has eibach camber bolt maxed out it's positive camber.

Stretched on 205/40/17 all around Saffiro tires.

You know my view! Low and wide is the way to go! Don't forget a deep lip haha. Can't wait to see your car with nice fitting wheels!

Btw, Silly, car is looking fantastic on those advans!

Thanks RabidTRD. I'm planning on running 16" wheel next and go stupid low. Might run on the same tire size as you. Maybe 16x8-9.5. Stupid stretch and stupid low. Sounds nice. Lol.

the title to this thread sounds more like some kinky videos

Dude I almost choked on my dinner when I read this OMG.

Oh yeah Ted I changed it up a bit. Rather than 18x8 Im gonna go 18x9 +38 5x100 with a 205/35R18 tire, should still be a good stretch with the low profile Im seeking. And I found these rims in the dimensions I stated. I think they'll compliment the car whole lot better than silver too, plus I found $50 dollars cheaper.

This would look really good dropped about 2 more inches with a bit of negative camber in the rear to have the wheel tuck up to the fender

^ I agree

I can't physically go lower with that wheel setup until I raise the exhaust a bit lol. The rears def need a bit more camber. I'll be adjusting that in the spring.

2" more and the subframe would be 1" or less above the ground. Any diviot, I'd beach the car lol

Actually, hmm... I'll have to look at it again.

Excuses
If its not touching the ground, it can be done.
I've driven audi's less than an inch from the ground, its sketchy, but still doable. And no, I don't live in California haha

It's hard to daily a car that low here. Lots of holes and ruts.

Trust me, I live in Winnipeg, Canada. Our roads are beyond terrible, I just didn't want to add the cliche "and our roads suck here" comment.
Colder, and more of a freeze thaw than New York,

Can't really disagree but Rochester is real bad. The whole lake effect kills it. Still lower is better.

I cant wait to slam my car. Everytime I look at it Im like "Ugh needs to be lower" lol

Yeah idk about you being colder with more of a freeze thaw lol. We have a guy from Alaska that says Rochester is worse than Alaska. He says it's bone chillingly cold here compared to the -50 it gets there. Primarily because we have lake effect wind... When you have a 30 mph -40 degree wind blowing against you when it's 5 degrees outside, it's pretty impossible to move.

Also, it'll go from 50 to -10 over night (it did it 3 times this winter) and back to 30 again. There are so many potholes this spring, idk what I'm going to do lol.

Trust me, it's bad here lol. Yesterday was beautiful, today we got a fresh dumping of snow. It gets to -50 C here and we get awful prairie winds. I've perfected the "walking with your back to the wind" walk. This winter has been especially bad and has been fluctuating for the past couple months so the roads are full of ridiculous potholes that will swallow your entire car. I do not wish how awful this city is upon anyone lol.

Sounds like you guys need to move down here to Texas, or Cali or Florida lol. Is there anybody planning on stancing their 6gc or are in the process?

I think I'll stick in the hella-tucked crowd that I'm the only member of.

I'm with you

Low and slow is the way to go

Dude that is so sick

SAMBOO where in VA are you?!
Cause i have never seen your car

Fairfax

Really?
I grew up there. Live over in Ashburn now but in Fairfax a reasonable amount..
crazy I haven't seen your car yet.

soon it won't look anything like it does now, sanding it all down and taking the plasti dip off the wheels, then painting the whole car tiffany blue

Cool stuff.
Turns out I think my wife and I are moving back to Fairfax :banghead:
hopefully we'll catch up some time.

I need my car lower, I can see too much wheel well. Where is the best place to start? I am just beginning a full restoration on my 95 GT.

Best start is coilovers

Then raised a little






and dont forget fender rolling even the front ones

A little more? Ok


But i like this setting more...

can i join this now???

what are you riding on?

Megan racing coils

Is $1,000 the expected budget for parts then? They don't look cheap...

Paint it something like this?

https://www.facebook.com/photo.php?fbid=101...mp;l=7f1fb13ed6

SLAM IT CHEELA!!!!!! COILOVERS FTW!!!!

yes Joe! finally what you and I had wanted all this time. hahaha!

Yes sir!

I plan on stancing mine as well. Just looking for the right wheels to get, trying to get that perfect stance

not even 1 celica on them videos.

You should do it then!

In fact, I expect to see your car on the ground the next time I see you

...N You knoW THIS maaan!! (on Chris Tucker voice)

check out some of my pics with 18x9.5 +33 +23 with 225/40/18 tires

Well locally (Chi area) Im the lowest 6gen. but I have to check on the next meet, because Luis's is getting lower and lower every time we meet ,but he got bigger wheels.

Im going for 17”x 9 , but IM debating between +20,+22 or +25 with wide lip look.Just trying to get the best offset.