6G Celicas Forums

I want an sc SO bad it's just I can't afford to commute with one. Someday I'll have one.

I'm hella jelly!

Yea there were a couple nice cars, but then the rest My favorite had to be the turbocharged V-6 Camaro

Saw your car at the Ikea meet the other week, but didn't see you. What are you lowering her on?

^ 98 civic with a 99-00 front end, the Si wasn't offered until 99-00 and only as a coupe...

I want something pre-smog either a Datsun 510/240Z or Porsche 911/912. If only I could sell some of my Honda's

Don't quote me on this, but I believe VTEC can only be engaged when traveling over 15 mph. The high redline should be able to achieve that even with a relatively low gear ratio. If it wasn't raining I'd seriously be tempted to try it

I'm thrown off by the front bumper. Isn't it from the later years of the production run? Great looking 7th gen!

That dude cracks me up!

I'm glad you got rid of those springs!

I saw you guys yesterday, but didn't have time to stop...

Here's one of my cars(Don't let the 13's deceive you)


The reason I brought up toe is because when you lower the car it toes out.

I don't run camber kits on any of my civic's(3 all of them moderately lowered). What really destorys the tires is the toe not being in spec. It might be more cost efficient for you to just get stock springs if it's a daily to get the car back to stock height(could be found at pick n pull or craigslist for dirt cheap I'd imagine). My gripe with aftermarket front camber kits is the ball joints are terrible, and will fail rather fast.

Don't forget to check the bushings if the car has lots of miles.

Looks like a decent pickup. If you want to get rid of your leather seats for some mad jayeeem tyte seats let me know. What meet was that?

Been around them(Vw's and Porsche's) my whole life. My father and I built this roughly two years ago


At one point we were boosting on the 1915


And I'd love both the 356 and the Woman driving it.

Sweet build! How many of those two doors were made, I have only seen 2-3 in person.

Karting is very awesome, I've been helping my friend alot lately with his shifter kart. He got to run Infineon with it yesterday!

Here's an old pic of it


In exchange for me welding a new gas tank they are going to let me race his old cart!

I'm very jealous of the relaxed regulations.

Great build. I say polish the Volks.

It's killing me waiting for it to arrive(well not really because I'm so busy with school). That first picture of the Supra is incredible!

I turn on my PS3 and it say's something to the effect of"your hard drive is corrupt" and proceeds to attempt to restore for hours on end.

I miss Tig welding, but it wasn't offered this semester. I need to get my hands on one!

I'm SO excited for this game. My ps3's harddrive took a crap on me a month ago so perfect timing to get the 360 out.

Looks good. Your stops/starts are pretty good too(my worst area for some reason)

I'm a big tig welding fan, but even I would use a mig welder in your situation. At home I use a 220V Miller, and I've done exhausts, new floor pans, Subaru crank pulley holders, etc.

The learning curve on a tig welder is very steep compared to mig imo. Also you have to figure the cost to purchase and operate the machine. How would you weld in that situation with your filler rod in one hand, torch in the other and modulate the foot pedal or run on lift arc.