6G Celicas Forums

how much for upper support bar + rubber seal ?

most likely. I havent installed a C-one bumper but if its anything like the GT4 the crash bar will need cutting. Try and find out which part of the bumper is hitting the bar and cut the bar accordingly

are there any write-ups on people putting quad throttle bodies on their 3s-GE's?? I did a quick google and found some custom manifolds to fit the throttle bodies, but im still unsure as to how much work and additional costs theres gonna be.

http://www.compsystems.com.au/index.php?pa...t&Itemid=13

woah very interested, are there other lips available for the GT4 front bumper?

ill be seeing you guys there

once i fix up my front end :S
without the upper support bar and spacer it looks a bit dodgey

also, you should paint it STi blue

yo 20V, in the first pic in the background theres a car parked in a driveway, thats where i was working on my convert... im suprised you didnt see me

haha i know the place ur talking about, a week after i bought my parts from japanautos, i found their site and the photos the the GT4 they were parting out

I still need the upper support bar and the rubber seal, i got the cut reo bar on today, but its made a huge ass gap between the bonnet and bumper

supercheap auto has a set of 100mm fog lights which are INCREDIBLY easy to fit, they come with a bracket and some screws, mounting them in the bumper took 5min

lol mate im at my mates place in milperra now cutting the front bar... thats not your gt4 in keysor place is it??

so far so good
cutting the bar and putting some foglights on today, wish me luck!!
I live in picnic point, which is about half way between bankstown and the shire

Ok here are the photos, from what ive gathered its the bottom edge that hits against the bumper, but i had a quick look at the crash bar mounts and it looks like top may hit against it too, not sure about that.


I've gathered i have to cut across these 2 lines

ill take some photos in a sec, just charging the camera battery.

im curious as to which side needs to be 'trimmed back' to fit the bumper, is it the top or the bottom of the crashbar?

I took my gt4 front bar to the paint shop recently, and they handed the reobar back to me saying it wouldn't bolt up with the new bumper. I know it needs to be cut in order to fit on, just curious where it needs to be cut and what tools i should be using to cut it. I have a fair bit of experience using power tools, but I haven't cut metal before, would an angle grinder with an appropriate wheel be sufficient?

I need the reobar to fit on by friday so it can pass my registration inspection

the front bumper i bought came with neither, does anyone have some spares or know where I could source them from?

ive got a GT4 bonnet, front bumper and bonnet latch from a wreckers. my mate whos a panel beat is going to put them on this weekend to see if it fits alright. apart from the usual complications (crash bar etc), will there be any others because i drive a vert?

I sent them an email.

Does anyone know the part number for an OEM convertible rood?

thanks mate that would be a huge help

Hi guys, I'm a long time 6GC reader, first time poster... I love the great community you guys got going on here, I've found it very helpful in the past.

Anyway to my question, the roof of my vert is in very bad condition and needs replacing. Ive been quoted $2800AUS to for a replacement and install, but one shop told me the cost can be significantly reduced if i source my own roof and pay for the labor only, which he quoted me to cost $950.

I've seen some roofs on the american ebay, I was wondering if they are all the same (USDM and JDM) or will they not fit? My car is a ST202 GT vert if this helps anyone.