6G Celicas Forums

Try to run a scan tool and see if and check the trouble codes on it, might be a knock sensor or something else...

That along with brake fluid, fuel sock (in tank) and fuel filter, clutch fluid. If your car has high milege i reccomend not doing a tranny flush.

I agree to that. lol Well it depends on how long you've owned your car and what's been replaced prior...

wow, he was going to trade his celica for a skyline?

you might want to do your spark plug wires too...It all depends on how long ago they've been changed.

You can still run a scan tool on it, just go find a place that has the OBD1 connectors.

Well there really isn't a way to improve your gas milege unless you believe those things on tv. But what are you running under the hood right now? Are you lightly modded with an Intake and exhaust?

Try tightening the belt first, if it still squeeks then replace it, it's most likely then all worn out and can possibly start to dry rot.

Im just putting this out there....Saves you time and the hastle...ebay

BTW....this post was from awhile ago...I totally forgot about it till I was browzing and seen pplz were replying...lol

I know I've posted sevral times...I've done swaps in the past...This is something new me and my buddy are willing to try...I also got helpful friends that have done AWD conversions that are also gonna help. I've been looking everywhere for an ST205 Engine and Trans but no luck with my searches...I've tryed the stickys too..but they had nothing...sorry... =/

How much did you pay for your ST205 3s?....Just kidding...Im stupied..

Is there anywhere that sells upgraded alternators for an ST?? My buddy needs one I havent found any..

Wow..Im not used to seeing a vert with that much wheel gap..Maybe it's because mines modded..lol..Its sweet to see a girl in a celi tho! =)

You shoulda just gotten a cheap intake from Ebay...so then you dont have to do fabbing..But is yours short ram???

I gotta find a ST205 3SGTE very fast and pretty cheap. I need AWD trans, and ECU. Someone help me! I need to know where I can get them for a good price!

Im looking for a front clip off an ST205. I was planning on the ST185 motor but I believe I came across a website that had the front clip for lil over 2k. I would like to know if anyone else know's where I can find them for around that price....

No I have a 6th gen Celi. I was looking for an st185 3SGTE streight from an Celica. Is your motor streight from an MR2?? I found an ST205 front clip. Im now in search for the ST205 Rear Axle and drive shaft. If anyone know's where I can get those I would love to know. Thanks,

Alex

Engine

Im looking for an st185 3-SGTE to buy. I want a place where I can trust and rely on them for getting me the engine...Anyone know of anyplaces where I can get some?

Now that I have the diagram's for the 3-sgte now im gonna need the 5-sfe diagrams. Its so i can start piecing wire by wire on what to do without actually thrashing everything. So if anyone has the 5-sfe diagrams....i would love to have them....
~Alex

__________
96 Celica Vert

Ill make it happen.....just watch

all i have to say is good luck...im starting mine by the end of feburary..

___________________
96 Celica Vert

I need the wiring diagrams for the st185 3SGTE and also for the 6th gen 5SFE. Im planning to do the 3S swap in acouple weeks...just need more information...

_________
96 Celica Convertable
87 Mazda Rx-7 Turbo 2

Dude...simple just slap some coil over's and front n' rear srut bars....slam your car to the ground...I slammed mine 4 inches but no aftermarket srut bars...Dropping it really improves the handling...taking corner's at higher speeds....mmmm lol =)

~doggy...good luck with your drifting...i bet you'll slam into something because when you turn...that's if you turn you'll just slide....The lil blizzard thing we just had the other day in Ohio I went to turn but turning was not an option...I found it very usefull to drift every turn so that I could make it completely...