6G Celicas Forums

Welcome Guest ( Log In | Register )


Jan 7, 2013 - 9:35 PM Forum: General Discussion · Post Preview: #998759 · Replies: 13 · Views: 2,723
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


QUOTE (GMan @ Jan 7, 2013 - 10:05 PM) *
QUOTE (Nespeed @ Jan 6, 2013 - 10:41 PM) *
Thanks for all the info, this will save me a lot of time. I had looked over the car and notice ill have to find a different gas tank or run a cell, and fab up mounts for the carrier bearing for the drive shaft. If I have a rear AWD subframe that should bolt up, correct? So next step is to find me a GT4 clip!


The ST205 rear floor pan is unique to the GT4. The GT4 sub frame will not bolt up directly to other models.
Need to fab up mounts. I can and has been done. Not hard if you are good at welding. :-)
Gas tank for an ST205 or an ST185 could be used, just hangs a bit low.

Have you done a search for ST205 or AWD swaps ?
There were two in the MA area.

Regards;
------------------------



Oh ok, so my only concern is messing up the geometry of the suspension if things aren't straight. I have plenty of welding hrs, are these major changes to the mount locations on the subframe? I will do some seaching, thanks.

Jan 6, 2013 - 10:41 PM Forum: General Discussion · Post Preview: #998679 · Replies: 13 · Views: 2,723
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


Thanks for all the info, this will save me a lot of time. I had looked over the car and notice ill have to find a different gas tank or run a cell, and fab up mounts for the carrier bearing for the drive shaft. If I have a rear AWD subframe that should bolt up, correct? So next step is to find me a GT4 clip!

Jan 6, 2013 - 7:35 PM Forum: General Discussion · Post Preview: #998667 · Replies: 13 · Views: 2,723
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


QUOTE (RabidTRD @ Jan 6, 2013 - 6:43 PM) *
The chassis is the same for the ST and GT.

Brakes are drum in the back of the ST and the GT has disk. ST has a different engine, hence different mounting locations, but the holes for the GT mounts are still there / indents in the frame are there. Most ST's don't come with the front factory strut stabilizer bar. Sway bars can be different, but they're different throughout each model as well. I guess it depended on who was putting the car together that day.


Great, thanks for the info. Picked up a 94 st for nothing, and trying to figure out if its worth getting a gt4 clip. Just want to understand what I'm in for with this project. Having a difficult time gathering factual information from many celica forums, I've been around the block and the hardcore info is scares.

Jan 6, 2013 - 4:45 PM Forum: General Discussion · Post Preview: #998653 · Replies: 13 · Views: 2,723
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


What about motor mount locations?

Jan 6, 2013 - 2:21 PM Forum: General Discussion · Post Preview: #998643 · Replies: 13 · Views: 2,723
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


Just looking for info on the major to minor differences between a AT and ST chassis.

Dec 22, 2012 - 12:30 PM Forum: Buying/Selling · Post Preview: #997516 · Replies: 4 · Views: 1,390
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


550 plus my hood and crash bar?

Dec 22, 2012 - 12:15 PM Forum: Buying/Selling · Post Preview: #997515 · Replies: 55 · Views: 20,181
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


Pmed

Dec 18, 2012 - 7:48 AM Forum: Buying/Selling · Post Preview: #997185 · Replies: 0 · Views: 552
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


Look for a engine harness for a 1.8 auto

Dec 18, 2012 - 7:46 AM Forum: Buying/Selling · Post Preview: #997184 · Replies: 2 · Views: 968
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


Ya

Dec 15, 2012 - 5:34 PM Forum: Buying/Selling · Post Preview: #996985 · Replies: 2 · Views: 968
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


I need driver and passenger out window weatherstrip seal sill

Dec 14, 2012 - 3:58 PM Forum: Buying/Selling · Post Preview: #996937 · Replies: 16 · Views: 2,392
Nespeed

Enthusiast

Joined Dec 13, '12
From MA
Currently Offline


Pmed


New Posts  New Replies
No New Posts  No New Replies
Hot topic  Hot Topic (New)
No new  Hot Topic (No New)
Poll  Poll (New)
No new votes  Poll (No New)
Closed  Locked Topic
Moved  Moved Topic
 

Lo-Fi Version Time is now: January 11th, 2026 - 12:38 PM