6G Celicas Forums

I’m looking for a 7afe exhaust manifold. Other exhaust sections are also welcomed.I have a 1994 celica st.

Thanks!

Yeah, US spec has an o2 sensor in the header before the "pre-cat" and another sensor before the catalytic converter.

I'm still looking if someone has one available. If it comes down to it I'll buy a new one, but if someone has one they lying around, I'm interested. Thanks for looking.

This might be an option. Let me know the specifics.




I don't think this header will work as I need the o2 bung. It also looks a good bit longer than US spec.

I recently discovered my exhaust manifold has a crack in it and I need to replace it. Does anyone have one lying around that they would like to get rid of?

Thanks!

The sound stays about the same throughout rpms, other than the obvious noise due to engine speed. It never sounds obnoxious in my experience, just a low hum.

Agreed. Love my flat black Vibrant. Magnaflow is good too. Don't get a fart can.

Bought them from a member on this site

The paint on these Celicas seem to hold up really well if they are maintained, especially the metal. I've found that bumpers, door handles, and side mirrors need some TLC after a while though.

Have you ever buffed it?

Sooo nice. How much has it been in a covered garage over those last 18 years? It has been well maintained.

Nice. I'm curious. What are the dimensions?

I came to the same crossroads you are at about 10 years ago when my OEM cloth seats started coming apart.

I ended up ordering a set of custom fitted leather covers for front and rear seats from Katskin.com and had a upholstery place install them. They placed some new foam in the seats and put the covers on. When it was all finished my seats looked really great. The fitment was perfect and you couldn't tell they were aftermarket seats to the unknowing eye. See my profile for a picture.

I also paid about what your upholstery place quoted you for covers for front and rear seats and install. They still look great to this day, 10 years later, except minor wear/fading.

HOWEVER if I had to do it again, I would go with a set of nice set of used OEM seats from an ST205--OR a classy set of aftermarket bucket seats (Recarro, Corbeau, etc) in the front and leave the back as they are or take them out completely. Who really uses the back seats anyway??

Thanks for the compliments. I always wondered what stockies would look like with 25mm spacers too, so I bought some and found out.

I wish Toyota would have made the cars this width in stock form. Instead, they gave us wide fenders with very little to fill the gap.

My car has not changed much over the past few years, but I kinda love the simplicity of her. Somewhat recently I put 25mm spacers on the car and took some pictures, so I thought I would share.

I'm about to turn 28 and I've had my Celica since I was 16, so I've had her for 12 years.

BUT to answer you Tigawoods, my parents bought the car new in 1994 and gave it to me when I was 16. Basically one owner since she was new, 18 years ago.

Those wheels/tires look great and it will really look clean once you lower it. I like the beefy tires. They look better and ride better, but you will probably need to look into rolling the rear fenders at least.

PM'ed about spacers

The 7afe may lack power but not many engines can hold up this long with so few problems

Mine just hit 210,000. Congrats on 300,000!

Lots of nice Celi's and GT4s on this page!

Libido.....haha

^ very clean. Of course I like the 3L2!

PM'd

Springs have been sold for a while. They are on my car now.

I understand that it is a 2nd gen 3sgte, but do you know what the motor come out of?

Taken from a sticky: 2nd Generation - 200 HP(USDM '90-'93 Celica All-Trac, USDM '91-'95 MR2 Turbo), 221 HP(JDM '90-'93 Celica GT-Four, JDM '89-'94 MR2 Turbo), 231 HP(JDM '90-'93 Celica GT-Four RC)

Really great pictures

What camera do you have?

Most of your links do not work.