6G Celicas Forums

Hi how much was you looking at for the converted loom please ?

No Im based in the uk.

And no never done the swap before like said was told by seller of the engine and all parts how easy it is and it's a simple bolt on bit already starting to see that this isn't the case at all. Thanks for link will take a read

Hi all new to group I was told that you guys may be able help me out on here.

Well where do I begin I had recently brought my 2nd st202 import 6th gen and then the problems started. Took it to garage to be professionally fixed and after a bodged helicoil and swarf in my engine she was no more. Now being my daily I needed to get her up and running again quickly. I have three more weeks till I lose mg hire car to finish her and when the pars came up for the conversion and the seller advising me how easy it was to do I thought why not let's convert her. I will lost all the parts I have been given and any help or known problems I am going occur etc then all hell and advice will be greatly appreciated guys.

I have the following

Rev2 3sgte engine out of a jdm import
All wiring loom and sensors on engine also
The cars gearbox which I have removed as no can run on my standard st202 for now
I have the turbo and a spare
Two different sized intercoolers also bit stuck there ?
Full down pipe , modified manifold and decat pipe

I need to know wether te existing wiring from st202 can fit or if need to run whe new loom off new engine.
Also in regards to intercooler what one do I use and can I use standard for now until fit a front mounted at later date ?
And also any other snags or problems or pars I will need along the way.

I need her running at the moment for commuting work and at later date will play at modifying for bhp etc

Thanks in advance people

Rob