6G Celicas Forums

let me know if you end up taking the back light off , for sale. Im willing to travel up there.

I did the 4th gen 3sgte swap over the winter and I had a custom made exhaust from the downpipe back. You can put whatever cat and exhaust you want on it. A good exhaust/performance shop should be able to bend pipe and fab up what you need. The first step is to determine what type of downpipe you want to use. The stock one is 2.5 inches in diameter and comes with a catalytic converter, but most aftermarket ones are 3 inches in diameter. Also, you need to decide what diameter exhaust you want. I did an aftermarket 3 inch downpipe but had the exhaust shop do a 2.5 inch exhaust from the downpipe back with a Magnaflow cat and muffler. I did this mainly for sound because I felt a 3 inch exhaust would be too loud. Make sure you check with the exhaust shop because some of them require you to keep the stock cats or will only remove a cat as long as you replace it with another.

i see your new.

ST202 and ST204 are both liftback chassis, they just have different engines.

an hks hi power for an st202 will fit onto your chassis with slight modification. because i dont know how far your downpipe goes into the underside of car or if you have an aftermarket catalytic converter.

but its a low exhaust an is 57mm and then 62mm right before the muffler. i have a fujitsubo for sale but most don't want n/a piping size because 60mm inner diameter isnt sufficient for a 300hp turbo engine to make the most power