| May 30, 2009 - 2:07 AM | Forum: Interior/Audio/Electrical/Wiring · Post Preview: #776657 · Replies: 114 · Views: 67,691 |
|
Enthusiast Joined Feb 4, '07 From queensland australia Currently Offline 
|
Very nice work and attention to detail with photos is very helpful. When desoldering try using a desoldering tool - it's about $10 and a bit like a large syringe that you press a button on and it sucks up the hot solder - I use one all the time. I notice that you had wet carpet last year - did you find out where the water was coming from? My floor is wet on one side of the car but seats are dry and no obvious roof leaks? |
| Feb 6, 2007 - 12:53 AM | Forum: Interior/Audio/Electrical/Wiring · Post Preview: #524303 · Replies: 13 · Views: 4,965 |
|
Enthusiast Joined Feb 4, '07 From queensland australia Currently Offline
|
QUOTE(DSToyo @ Jan 27, 2007 - 2:54 PM) [snapback]521813[/snapback] -allright ive replaced both the bulbs (front and back) and nothing happend. -i think the problem is with front blinker because it only blinks half as bright as the other -would the wireing be screwed up -can i make the drivers side blink faster too to match the passenger side -each blinker has the same bulbs You say that the other side of the car is working fine - this means the globes/relay/earth on that side of the car works, so , - remove all the globes from the "faulty side of the car" and put them to one side - remove all the globes from the "functioning side of the car" and put them in the "faulty side of the car" - test lights this will show you if it is a globe problem - hopefully it is and u have a fault in one of your globes because, as you say, you have little experience with relays, and earth faults can be a real bitch to track down sometimes. Good Luck |
 New Replies No New Replies Hot Topic (New) Hot Topic (No New) |
 Poll (New) Poll (No New) Locked Topic Moved Topic |
| Lo-Fi Version | Time is now: September 13th, 2025 - 3:04 AM |