6G Celicas Forums

I have a wiring harness built by Tweak'd Performance. I know that a few of you guys on here have ordered harnesses from Tweak'd and/or have better knowledge of how this works. I am not able to get power to the car. I have been instructed to connect the following:

CEL goes go your II1 body plug pin 7
tach goes to II1 pin 3
OIl goes to II1 pin 2
Temp goes to II1 pin 10
Reverse (red) goes to II1 pin 9
Reverse (black) goes to II1 pin 12

I haven't been able to figure out how to wire the ign hot wire, the spd wire, and the starter wire. I have connected the starter wire to a thick black wire I believe is connected to the starter and wired the fuel pump wire to a thick blue wire with black stripe that is on one of the body connectors. I did a little research and was able to find that the fuel pump is supposed to be connected to the positive wire connected to the fuel pump, but im not sure I have the right one.

I'm not sure where to attach the following:
http://i109.photobucket.com/albums/n80/dum...aj/IMG_5490.jpg
http://i109.photobucket.com/albums/n80/dum...aj/IMG_5494.png
http://i109.photobucket.com/albums/n80/dum...aj/IMG_5491.jpg


Im thinking the orange one with a fuse attached to it is suppose to go to the Positive terminal on the battery. There is a ring with multiple brown wires connected to it that I'm guessing I should ground somewhere and then there is a plug that I don't know where it goes at all. Any help would be appreciated.

This post has been edited by stinkyfeet: Mar 30, 2014 - 3:41 PM