6G Celicas Forums

***UPDATED INFO BOTTOM POST***

Send Me Your Light Unit: $55 Shipped US(+$10 to CAN/+$15 Everywhere Else)
For those of you who dont DD you car and can be without a high mount for a week or so, you can send me your unit and I will put a board in it and send it back to you (it will be plug and play).
***I need the whole light housing (dont need the mounting plate) along with the female connector that is attached to the bulb.


Plug and Play Unit Sent To You/Buyback: $70 Shipped US(+$10 to CAN/+$15 Everywhere Else)/$15 rebate
I send you a complete Plug and Play unit to replace what you have ($70). For a rebate, send me your old unit after you install the new one and upon receiving your old unit, you will receive a $15 Paypal Rebate - this will help me to continue to make more units!
*** For a full rebate I require the whole light housing/rubber seal/ female connector thats attached to the bulb. If you are concerned of the condition of the one you are sending back to me just PM me, I understand that the seal on the lens has a tendency to crack up and in some cases can be pretty bad.


******
PM to ORDER

To start off I would like to get a couple people who are willing to send me their stock units back.
I have a couple boards that need housings and that would help me get these out a little faster.
I only have 2 Plug and Play Units ready to ship so again, this will be a slow start.
******


How the LED Unit is made


video1 (i have a strobe on the light fyi, sorry for the phone quality)
http://vid35.photobucket.com/albums/d176/M...zpshyzez8tz.mp4

video2 (before install)
BEFORE INSTALL

Installed Unit
[color="#8B0000"][/color]

This post has been edited by Tigawoods: Apr 3, 2016 - 7:27 PM