6G Celicas Forums

I was wondering if those who have replaced their passenger side axle with a new or remanufactured one ran into this problem. Did the one you purchase come with the bracket (bearing) where the two bolts are to be screwed in.

the ones i found at pepboys and o'reilly and Napa does not come with that bracket. When i had replaced it a 3 years back - i did not remember removing that bracket from old one to new one. I believe it came with the one i purchased. The store said I would have to remove the bracket from the old one, but it seems difficult to remove. Any help is appreciated

This post has been edited by 2bcelica: Dec 10, 2008 - 5:29 PM

if it didnt come with one on the new axle, you'll need to have the old one pressed off the old axle then installed on the new one.

it "should" come with a new one tho...are you sure its the right axle?

comparing side by side - its identical except without the bracket -- the only thing i was able to do was have the sales guy double check because I thought it was the wrong part too - but he confirmed several times -- even the online picture from napaonline.com shows it without the bracket. I'm not sure where I purchased mine last time, wished i could remember so I would reorder one from the same place.

Thanks

found the solution - after looking at the toyota axle diagram - there's a snap ring that you have to remove before you can hammer it out - off to the store to pick up the new part - thanks for the input though