6G Celicas Forums

Hello everyone

I have been lurking around this board for well over a year, and now finally decide to post! I would like to first all thank everyone for the amount of amazing information that is on this board, and a big thanks for the write ups on the swaps.

A little bit about me if you care... Im up here in Edmonton Alberta Canada, i am a heavy duty mechanic... i ran a Service truck in Fort McMurry in oil sands game for a few year and then now i am back at our home base till the economy pics up again. This is actualy the first car i have ever owned, my last truck was an Amarillo editon F-350 diesel and now i am driving a H2 sut.

on to my story

I purchased my Celica about 1 year ago, as a project car and somthing to just play around with in the summer, i put in the Tein springs and KYB strut and of course dont forget the GT-4 riser blocks!!! please note the 6GC sticker!!!


of course i had to do the 7th gen seat swap


which leads me to my latest mod the 3sgte


Everything has gone so buttery smooth so far with the swap thanks to your great info and writeups!
Which leads me to the questions

1 - i am absoulty stuck on the clutch start switch, i have gone through the st205 body wiring in the service manual, i have gone through the 3sgte service manual... but no luck i can find the IJ1 plug between the tvss and the starter which are the Yellow/black and the Black wire, but i CANNOT find a wiring diagram with the actuall clutch start switch (the BGB wiring diagram on celicatech is down) i have read the write ups so many time but i just cant figure them out!!!!

here is a pic of the 3 body harness plugs on the 3sgte harness


I appreciate the help in advance and if you cant help i hope you at least enjoyed the pics