 Gen III 3sgte sensor?? question... |
 Dec 22, 2012 - 10:54 PM
|
 
|
 Enthusiast  Joined May 13, '06 From Kaimuki, HI Currently Offline Reputation: 10 (100%)  |
So as most of you know, I've been trying to find parts for a previously parted out Gen III engine, I have everything on it now from what I can tell. What I don't know is what goes where I have the masking tape flag hanging down, oil keeps spraying out when I try to crank it so I plugged it with a water temp sensor. I'm guessing a sensor goes there. The view in this pic is looking up from under the engine above the oil filter. If it is a sensor that goes there it doesn't matter because I have all of the sensors that I need connected right now for the EMS to run the engine. I don't see anything about it in the oil routing diagram of the 3sgte manual, so I know it isn't an oil feed to something. Is it a sensor? If so I'll just leave my water temp sensor in there and seal it off.
So can someone tell me what goes here? 
-------------------- -Jay
95 GT conv. project car: Manual, Gen III 3sgte, JN pisons, Eagle rods, overbore, crank knife-edged, crank scraper, ARP head/main/flywheel, Autronic EMS, Haltech Dual Wideband O2 controller, Audi 1.8T individual coils, FMIC and SSQV BOV, 3" downpipe, 3" ultra-high-flow cat, 2.5" Borla muffler, +other 01 S2000: FMIC, Haltech EMS, Haltech wideband, 570cc inj, forged pistons/rods, sleeved block, 5 angle valve job, ported and polished 02 R6, all stock, except for braided stainless brake lines, frame sliders, and adjustable brake/clutch leve |
Posts in this topic
match220 Gen III 3sgte sensor?? question... Dec 22, 2012 - 10:54 PM
dkdmonk It's kind of hard to tell from your picture bu... Dec 22, 2012 - 11:32 PM match220 That's all I needed to know, thanks! I gue... Dec 23, 2012 - 4:09 AM
RoyO QUOTE (match220 @ Dec 23, 2012 - 11... Dec 23, 2012 - 6:02 AM match220 What is the thread size of that reducer? I looked ... Dec 26, 2012 - 11:39 PM delusionz most likely someones wound in an NPT into a BSPT
... Dec 27, 2012 - 5:46 PM match220 QUOTE (delusionz @ Dec 27, 2012 - 12... Dec 27, 2012 - 6:31 PM delusionz check if its a tappered thread, if it is, then its... Dec 27, 2012 - 11:24 PM RoyO I don't know the thread size of the reducer an... Dec 28, 2012 - 1:44 PM 96stgreendemon Pretty sure it's 1/4" mpt you need to plu... Jan 11, 2013 - 12:59 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: December 15th, 2025 - 11:06 AM |