Before i start with this swap Options

[Supersprynt]

Ok in about a month i am planning on buying a JDM 3sgte - i wanna know a few things like:
which generation is the 225hp?
can i use an mr2 pressure plate, and is that the only thing im going to need as far as clutch goes?
Can i use the MR2 turbo Limited Slip?
Does anybody know where i can pick up a 3 gauge pod for a/f meter, boost meter etc.

[BigEdge169]

There is a group buy right now on celica.net for a group by on a full pilar with 3 gauge pods. Here's a link to it
http://celica.net/cgi-bin/ultimatebb.cgi?u...c;f=25;t=000279
I'm not really sure where everything is at, I think they are waiting on final prices and all that good stuff.
Good luck with the engine.

[Supersprynt]

They have a pillar somewhere, i've seen it on a Celica. Can anybody help me out with the other stuff?

[Guest_Matthew_*]

you can get the full pillar from a supra or 95-99 eclipse. remember sand paper goes a long way.

[FallenHero]

sand paper and a hair dryer

[Charlie97L]

QUOTE (Supersprynt @ Feb 27, 2003 - 3:36 PM)

Ok in about a month i am planning on buying a JDM 3sgte - i wanna know a few things like: which generation is the 225hp? can i use an mr2 pressure plate, and is that the only thing im going to need as far as clutch goes? Can i use the MR2 turbo Limited Slip? Does anybody know where i can pick up a 3 gauge pod for a/f meter, boost meter etc.

you should get an st185 clip, the 90-93 JDM gt-four celica... that is the one with 225 HP. if you use an MR2 engine, you will have large headached, because the engine is set up a lot differently. and no, you can't use the LSD from the MR2, but TRD makes one for the celica GT, about 650.

[Guest_Matthew_*]

good point


go to www.jarcoinc.com for the best prices on the st185

and any engine/clip for that matter.

[Supersprynt]

Thanks - i gotta use the GT tranny so i dont wanna go over around 250hp - right now
225 plus the exhaust and whatever else is going to be added i should be fine - thanx fo the advice.