 FS: Misc Parts |
  |
 May 6, 2012 - 11:48 AM
|
 
|
 Enthusiast  Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%)  |
I have the following parts remaining after just selling my celica:
Engine/Transmission Parts 1) 1 Brand New (Sealed) 5SFE ACT Release Bearing (Part #RB442, this is basically an OEM part) - $20  2) 1 Used OEM 2nd gen 3SGTE Oil Return Hardline w/ rubber hose and clamps - $10  3) 1 Used OEM 5SFE MAP Sensor - $2 Exhaust Parts 4) 1 Brand New (Never Opened) Vibrant 2.5" Stainless Steel Straight Pipe (5 Feet long) - $50 Intake / Intercooler Parts: 6) 1 x High Temp Silicone 4-ply 2.75" Black Straight Silicone Coupler (3") - $5  7) 1 x 2.25" Black Straight Silicone Coupler (slightly < 4") - $3 8) 1 x 2.25" Black Straight Silicone Coupler (cut at an angle, slightly < 3" to 3") - $3 10) 1 x 2.75" Stainless Steel T-Bolt Clamp - $3  Oil Filter Relocation Parts: 11) 1 Earl's Perform-O-Flex Braided Stainless Steel -10AN Hose (about 6 Feet in length) - $30  Exterior Body Parts: 16) 1 OEM '98 Front Bumper in silver (normal wear/tear) - $75 18) 1 OEM '98 Hood in silver (normal wear/tear) - $50 Sold Items: 5) 6 x High Temp Silicone 4-ply 2.25" Black Straight Silicone Coupler (3") - Sold 9) 10 x 2.25" Stainless Steel T-Bolt Clamps - Sold 12) 1 pair of Brand New (never installed) AeroCatch Plus Flush Hood Pins - Sold 13) 1 OEM Toyota T Emblem for the rear - Sold 14) 1 Brand New (never installed) Aftermarket Red Toyota T Emblem (Doubled-sided tape backing) - Sold 15) 1 set of Brand New (Sealed, never installed) Enkei Cover Plates for Enkei RS7 / OR52 - Sold 17) 1 set of OEM '98 Side skirts in silver (paint on 1 of them is a bit scruffed, but was touched up) - Sold 19) 1 Set of Stock Rear Strut Covers For Hatchback (it's the 2 covers inside the hatch area that covers the struts) - Sold 20) 1 TRD Leather Wrapped Ball shift knob - Sold 21) 1 Set of Red TRD Seatbelt Shoulder Pads - Sold 22) 1 Set of Brand New, (never installed) AutoVation Competition Series Aluminum Racing Pedals for 94-99 Celicas (4 Piece for Manual Transmission) - Sold 23) 1 TWM shortshifter for 94-99 Celica (Currently installed on stock shifter base, can be had with/without base)- Sold PM if interested. All prices are OBO so feel free to make me an offer for any parts. Prices are in CAD (Canadian Dollars). All parts are located in Toronto, ON Canada. Will ship at buyer's expense. This post has been edited by elvasoshexai: Feb 27, 2015 - 8:12 PM -------------------- |
|
May 6, 2012 - 10:52 PM
|
|
|
Enthusiast Joined Sep 25, '09 From Edmonton Currently Offline Reputation: 1 (100%) |
PMed!
|
|
May 6, 2012 - 11:16 PM
|
|
 Enthusiast Joined Feb 9, '09 From Toronto Currently Offline Reputation: 2 (100%) |
PM'd
|
|
May 7, 2012 - 7:48 AM
|
|
|
Enthusiast Joined Aug 18, '11 From Cochranville, PA. Currently Offline Reputation: 6 (100%) |
PM'd regarding the TWM short shifter and shift knob
Thanks Lamont |
|
May 10, 2012 - 4:32 PM
|
|
|
Enthusiast Joined Nov 25, '09 From Utah Currently Offline Reputation: 0 (0%) |
PM'd about the skirts
|
|
May 27, 2012 - 3:19 PM
|
|
|
Enthusiast Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%) |
bump!
-------------------- |
|
Jun 2, 2012 - 11:03 PM
|
|
|
Enthusiast Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%) |
To the top!
-------------------- |
|
Jun 3, 2012 - 8:31 AM
|
|
 Enthusiast Joined Jan 4, '12 From US Currently Offline Reputation: 6 (100%) |
Bumper and side skirt pictures?
Also, shipping of bumper to 00983 Puerto Rico? (expecting it to be expensive) -------------------- 1993 Celica GT Coupe - sold
1994 Celica GT Liftback |
|
Jun 11, 2012 - 1:24 AM
|
|
|
Enthusiast Joined Jan 29, '08 From Abbotsford Currently Offline Reputation: 4 (100%) |
PM'd
|
|
Jul 8, 2012 - 8:06 PM
|
|
|
Enthusiast Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%) |
Bump!
-------------------- |
|
Aug 2, 2012 - 9:33 PM
|
|
|
Enthusiast Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%) |
To the top!
-------------------- |
|
Mar 16, 2013 - 8:52 PM
|
|
|
Enthusiast Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%) |
Bump! Still have a bunch of stuff for sale!
-------------------- |
|
Aug 24, 2013 - 3:56 PM
|
|
|
Enthusiast Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%) |
Bump, feel free to make an offer for any remaining items
-------------------- |
|
Aug 25, 2013 - 12:29 AM
|
|
|
Enthusiast Joined Sep 13, '10 From Austin, tx Currently Offline Reputation: 3 (100%) |
QUOTE (elvasoshexai @ Aug 24, 2013 - 4:56 PM)  Bump, feel free to make an offer for any remaining items PM'd |
|
Aug 26, 2013 - 3:22 PM
|
|
|
Enthusiast Joined Mar 6, '13 From New jersey Currently Offline Reputation: 4 (83%) |
Still have the oil lines and bumper? (More importantly oil lines)
-------------------- QUOTE (Azncelica @ Mar 4, 2012 - 11:43 PM) I started with what I know to do, I swap engine into my car, I knew it was too much work to make it a AWD. I kept it FWD. Went to take a crack at doing the wiring conversion. Than, I realize, shoot, this is out of my league. |
|
Aug 30, 2013 - 4:08 PM
|
|
|
Enthusiast Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%) |
QUOTE (Arturio55 @ Aug 26, 2013 - 4:22 PM) Still have the oil lines and bumper? (More importantly oil lines) Yes, still have both -------------------- |
|
Oct 7, 2013 - 8:34 PM
|
|
|
Enthusiast Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%) |
Bump!
-------------------- |
|
Oct 9, 2013 - 11:22 PM
|
|
|
Enthusiast Joined Mar 6, '13 From New jersey Currently Offline Reputation: 4 (83%) |
QUOTE (elvasoshexai @ May 6, 2012 - 12:48 PM) I have the following parts remaining after just selling my celica: Engine/Transmission Parts 1) 1 Brand New (Sealed) 5SFE ACT Release Bearing (Part #RB442, this is basically an OEM part) - $30 2) 1 Used OEM 2nd gen 3SGTE Oil Return Hardline w/ rubber hose and clamps - $15 3) 1 Used OEM 5SFE MAP Sensor - $30 Exhaust Parts 4) 1 Brand New (Never Opened) Vibrant 2.5" Stainless Steel Straight Pipe (5 Feet long) - $70 Intake / Intercooler Parts: 5) 6 x High Temp Silicone 4-ply 2.25" Black Straight Silicone Coupler (3") - Sold 6) 1 x High Temp Silicone 4-ply 2.75" Black Straight Silicone Coupler (3") - $6 7) 1 x 2.25" Black Straight Silicone Coupler (slightly < 4") - $3 8) 1 x 2.25" Black Straight Silicone Coupler (cut at an angle, slightly < 3" to 3") - $3 9) 10 x 2.25" Stainless Steel T-Bolt Clamps - Sold 10) 1 x 2.75" Stainless Steel T-Bolt Clamp - $3 Oil Filter Relocation Parts: 11) 1 Earl's Perform-O-Flex Braided Stainless Steel -10AN Hose (about 6 Feet in length) - $40 Exterior Body Parts: 12) 1 pair of Brand New (never installed) AeroCatch Plus Flush Hood Pins - Sold 13) 1 OEM Toyota T Emblem for the rear - Sold 14) 1 Brand New (never installed) Aftermarket Red Toyota T Emblem (Doubled-sided tape backing) - Sold 15) 1 set of Brand New (Sealed, never installed) Enkei Cover Plates for Enkei RS7 / OR52 - $10  16) 1 OEM '98 Front Bumper in silver (normal wear/tear) - $75 17) 1 set of OEM '98 Side skirts in silver (paint on 1 of them is a bit scruffed, but was touched up) - Sold 18) 1 OEM '98 Hood in silver (normal wear/tear) - $75 Interior Parts 19) 1 Set of Stock Rear Strut Covers For Hatchback (it's the 2 covers inside the hatch area that covers the struts) - Sold 20) 1 TRD Leather Wrapped Ball shift knob - Sold 21) 1 Set of Red TRD Seatbelt Shoulder Pads - Sold 22) 1 Set of Brand New, (never installed) AutoVation Competition Series Aluminum Racing Pedals for 94-99 Celicas (4 Piece for Manual Transmission) - $70  23) 1 TWM shortshifter for 94-99 Celica (Currently installed on stock shifter base, can be had with/without base)- Sold PM if interested. All prices are OBO so feel free to make me an offer for any parts. Prices are in CAD (Canadian Dollars). All parts are located in Toronto, ON Canada. Will ship at buyer's expense. PM about front bumper? Live in new jersey, USA -------------------- QUOTE (Azncelica @ Mar 4, 2012 - 11:43 PM) I started with what I know to do, I swap engine into my car, I knew it was too much work to make it a AWD. I kept it FWD. Went to take a crack at doing the wiring conversion. Than, I realize, shoot, this is out of my league. |
|
Feb 16, 2015 - 2:31 PM
|
|
|
Enthusiast Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%) |
Bump! still have some items left
-------------------- |
|
Feb 16, 2015 - 4:04 PM
|
|
|
Enthusiast Joined Jul 1, '14 From Hawaii Currently Offline Reputation: 3 (100%) |
are the couplers 2.75" inner diameter or outer diameter? lol sorry I'm not too sure how those are measured
|
|
Feb 20, 2015 - 5:38 PM
|
|
|
Enthusiast Joined May 16, '05 From Toronto, Ontario Currently Offline Reputation: 8 (100%) |
QUOTE (Noahwhite2014 @ Feb 16, 2015 - 5:04 PM) are the couplers 2.75" inner diameter or outer diameter? lol sorry I'm not too sure how those are measured They are 2.75" ID -------------------- |
|
Feb 25, 2015 - 11:02 AM
|
|
|
Enthusiast Joined Jun 22, '14 From Quebec Currently Offline Reputation: 2 (100%) |
Parts received, thanks!
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: June 18th, 2025 - 5:20 PM |