 What's the name of this tool?, It is used to support wheel bearing on shop press. |
  |
 Jan 4, 2013 - 12:15 AM
|
 
|
|
Enthusiast  Joined Sep 9, '12 Currently Offline Reputation: 0 (0%)  |
Could anyone tell me what the round tool on the bearing is?
|
|
Jan 4, 2013 - 3:35 AM
|
|
 Enthusiast Joined Apr 18, '05 From Lincoln, Ar Currently Offline Reputation: 7 (100%) |
That's actually a pipe. Use a pipe that has the same diameter or a little bit smaller if you wish to press out them bearings.
|
|
Jan 4, 2013 - 4:52 AM
|
|
|
Enthusiast Joined Sep 9, '12 Currently Offline Reputation: 0 (0%) |
QUOTE (soulshadow @ Jan 4, 2013 - 4:35 AM)  That's actually a pipe. Use a pipe that has the same diameter or a little bit smaller if you wish to press out them bearings. Thank for explanation. Would you like to tell me where to buy such pipe? |
|
Jan 4, 2013 - 11:01 PM
|
|
 Enthusiast Joined Apr 18, '05 From Calgary Currently Offline Reputation: 20 (100%) |
don't use a pipe as it could buckle on you.
get a punch set.  -------------------- -------------------------------------------------------------------------------- -------------------------------------------------------------------------------- |
|
Jan 5, 2013 - 12:28 AM
|
|
|
Enthusiast Joined Sep 9, '12 Currently Offline Reputation: 0 (0%) |
QUOTE (azian_advanced @ Jan 4, 2013 - 11:01 PM) don't use a pipe as it could buckle on you. get a punch set. I understand what you mean. But the driver is used on the top of knuckle, while the pipe under it supports the knuckle so that the bearing is absolutely vertical to the press. |
|
Jan 5, 2013 - 1:18 AM
|
|
|
Enthusiast Joined Apr 18, '05 From Calgary Currently Offline Reputation: 20 (100%) |
Then what you need are some arbor plates.
 
-------------------- -------------------------------------------------------------------------------- -------------------------------------------------------------------------------- |
|
Jan 5, 2013 - 5:14 PM
|
|
|
Enthusiast Joined Sep 9, '12 Currently Offline Reputation: 0 (0%) |
QUOTE (azian_advanced @ Jan 5, 2013 - 1:18 AM) Then what you need are some arbor plates. I have a 12 ton shop press. But it is quite a challenge to fasten the wheel bearing strictly vertical to the press. I'll try your method. Thanks! |
|
Jan 6, 2013 - 7:02 PM
|
|
|
Enthusiast Joined Sep 9, '12 Currently Offline Reputation: 0 (0%) |
QUOTE (azian_advanced @ Jan 5, 2013 - 2:18 AM) Then what you need are some arbor plates. Do you happen to know where to get some cheap plates? |
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: October 25th, 2025 - 5:04 AM |