Long term living room project, Looking to build a 10k rpm 3sgte Options

[Neon90424]

Since i have pretty much completed my gt four engine wise. machined and head kit also installed. I feel like building a 10k rpm engine with a 3sgte. I was looking at 3sgte's and I have decided to go with the newer ST215 engine since I have found them cheap on Ebay for 1k, and have it shipped by boat to PY. Going to buy an engine mount and set it up in my living room.

I figure the side intake manifold is better flowing than the 3rd gen and COP system to be nicer for a high rpm flowing engine.

Im looking for advice and tips. My plan goes as follows.

Buy and bring the engine.

Major tear down with about 100 ziplock bags and catalog it.

Clean it completely. turn the pistons and conrods into some sort of table or ashtray or shot glasses.

Take the head apart. polish it. have it machined for .5mm over exhaust valves and 1mm over intake valves.

looking to go shimless bucket. TI retainers and BC valve springs.

machine the crank lightening it up as much as possible without unbalancing it and compromising its strength.

eagle rods and cp pistons. acl bearings.

maybe make a custom aluminum oil pan? I need advice on the oil pump and flow for this engine.

I will set up a nice Injector dynamics based fuel delivery system that can handle the injection speed for 10k rpm.

polish the intake manifold runners...


I need True and false advice. I read that the oil pump the st215 engine has is higher flowing and water pump as well.

the head has better flow and the manifold as well... The exhaust manifold and turbo is going to be sold.

This is going to be a 400-500 hp engine. the donor car is still not decided to me as I will complete the engine first and I will do this real slow say a year or 2 So i might pick up and ST185 and drop this in.

thoughts ideas advice? flame?

[celica74]

Your insane! i like it! Youll not only need almost a full on race cams, titanium valve-train, fully forged bottom end, and a pretty hefty tune. But also a turbo that will be able to keep up. If you going to go 10k rpm, you might as well shoot for 500+hp. I would also try to square out the piston travelxbore. The more square the better and the higher you can rev. Good luck.