Just ordered a 20V Blacktop what parts do i need Options

[onnaj]

Hello,

I've ordered a 4AGE 20V Blacktop engine today with about 98.000 km! Can't wait to have it here! It comes with the aircon pump, steering pump, waterpump, oil pump, alternator, plug wires, intake, exhaust header. The distributor cap is damaged, so can't use that one.

Besides that i've bought a uncut wiring harness and 6 speed manual ecu from a friendly guy from club4ag.com.

What do i all need to make the swap complete? I use my own C52 7AFE gearbox, think it can handle the ponies without problems This is my list thusfar:

1) Igniter and ignition coil
2) Timing and other belts and valve cover gasket (and maybe waterpump)? Thinking also of chaning to the ST oil pump, so i can use the ST tensioner, belt and waterpump because the hydraulic one on the BT fail sometimes. And ive heard BT is an interference engine, so i don't want that to happen.
3) Do the wiring
4) Get a distributor cap and rotor also i guess
5) Order the fluids
6) Change the clutch?
7) Change the plugs
8) ......

Hope you guys can help me out so i have all the parts needed

Thanks a lot!!

[Kwanza26]

No... the 7A A/C compressor probably won't bolt up. The blocks are different, accessory bolt holes, etc are different. It may be possible to fit the 7A's brackets and stuff so the compressor will fit, but that's just speculation... meaning I haven't done it and don't recall since it's been like 6-7 years since i've last touched a 4AG.

As for the throttle cable, I believe most from a non-cruise control FWD toyota should fit... but i may be wrong. The 90's tercels have a long throttle cable though and that's what i used in my AE86.

Also, the flywheels are different between the 7As and 4As, and vary based on years, and types. Older bigport 4AGs, pre 1990 have a 200mm flywheel, and are 8 bolts. 4A/E/F's (dual cam F head and single cam) of the same generations are 6 bolt 200mm. Later model 4AGs (smallports), 1990 thru to the Silvertop 20V have a 212mm 8 bolt flywheel. 7AFE's all have a 6 bolt 212mm flywheel. Blacktop 20Vs have a factory lightened flywheel, 212mm 8 bolt. However, clutches bolt up the same as the mounting locations are the same. The contact surface of the two types, 200mm and 212mm are slightly different but you can use the 200mm clutch on the 212 flywheel... and even in reverse (212mm clutch on the 200mm flywheel) but I wouldn't recommend it. Use the correct clutch kit. I believe this is across all A series engines regardless of whether it's a 6 bolt or 8 bolt crank. Also, i believe the 2ZZ series clutch kits also fit (212mm so I've heard), but I can't comment on whether the 2ZZ flywheels, which are 8 bolts will fit.

This post has been edited by Kwanza26: Apr 8, 2013 - 9:08 PM