4AGE 20V Blacktop with stock header, will it fit my stock 7AFE exhaust Options

[onnaj]

Hello,

As some of you might know i'm busy with a 4AGE BT conversion. Only thing i'm wondering now is when i put the 4AGE 20V header on the 7AFE downpipe if the lenght will be equal comparing it with the stock 7AFE engine with stock (4-2-1) 7AFE header?

As you can see on the pictures the itselves header fits perfect! Even the sizes are the same (both around 38.9mm = 1.566") All i need to know before the swap is if the lenght will be the same.

Pictures of the 'new' header with an old downpipe i had lying around :









This post has been edited by onnaj: Apr 23, 2013 - 5:33 AM

[soulshadow]

The connecting plate to the cat on my downpipe was cut off so I was never able to figure if it bolted up properly or not.
I do know that the 20V ST had different mounting spots on the downpipe to the frame which did not bolt up properly to stock. Your best bet if it doesn't work is to weld it on,.