![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() Joined May 4, '09 From coral springs florida US Currently Offline Reputation: 21 (100%) ![]() |
I realized that there is no much info about this spacer and I thought this might be helpfull for some people using e153 tranny on their swap.
I used lsd mr2 inners and st185 outters If you bolt the mr2 inners to the tranny and st185 to the hub you will have a gap of about 1/2 inches in the middle of the 2 axles. ![]() The spacerr was made out of the mr2 axle. This is the piece you remove from the mr2 axle to make the hybrid one. ![]() You need to cut this section which measures exactly 1/2 inch ![]() Then take the spacer to a machine shop to make the surface flat and flush ![]() ![]() Mount it to the st185 axle ![]() ![]() And get longer bolts and you are ready to install it ![]() -------------------- ![]() |
![]() |
![]() |
|
Enthusiast ![]() Joined Nov 15, '08 From Raleigh NC Currently Offline Reputation: 1 (100%) ![]() |
What did you use to cut the hard steel? I took the axle to a machine shop and he couldn't cut it
|
![]() ![]() |
Lo-Fi Version | Time is now: June 11th, 2025 - 3:42 AM |