 Brakes Wear Unevenly |
 Aug 25, 2013 - 3:51 PM
|
 
|
|
Enthusiast  Joined Aug 13, '13 From Burleson Currently Offline Reputation: 0 (0%)  |
My daughter and bf did a break job on the 99 GT last night. They noticed that the back pads that were on it were worn at an angle.
When the new pads (wagner) went on the back, they only had one shim....once they went on, they still made noise (rubbing) on the test drive....so my bf greased the slider pins...they still make a little noise at low speeds. Anyone have any idea what else could help? |
 |
Replies
|
Aug 25, 2013 - 4:28 PM
|
|
 Enthusiast Joined Feb 11, '08 From Auckland, New Zealand Currently Offline Reputation: 0 (0%) |
grease????? dont you just put the 2 backing plates back where they were and put the pads back in and pop the clips back on?
isnt it more likely that you drove through a puddle with hot rotors, warped the rotors, and thats why the pads are wearing uneven either that or the car is in need of a wheel alignment pretty bad? -------------------- Mike W
1996 Toyota Celica ST205 GT-FOUR GT2860RS turbine, TiAL mvr44, JE 86.5φ piston, Clutchmasters FX400, APEX P-FC 269awhp / 273ft-lbs |
Posts in this topic
Maggie73 Brakes Wear Unevenly Aug 25, 2013 - 3:51 PM
SwissFerdi Did you grease the rear of the pads where the pist... Aug 25, 2013 - 3:52 PM
Maggie73 QUOTE (SwissFerdi @ Aug 25, 2013 - 3... Aug 25, 2013 - 4:03 PM Maggie73 QUOTE (delusionz @ Aug 25, 2013 - 5... Aug 26, 2013 - 8:39 AM trdproven did you notice if it was difficult to press in the... Aug 26, 2013 - 12:57 AM Maggie73 QUOTE (trdproven @ Aug 26, 2013 - 12... Aug 26, 2013 - 9:32 AM mkernz22 QUOTE (Maggie73 @ Aug 26, 2013 - 10... Aug 26, 2013 - 10:21 AM mkernz22 The uneven pad wear is from the slider pins starti... Aug 26, 2013 - 8:48 AM Maggie73 QUOTE (mkernz22 @ Aug 26, 2013 - 8:4... Aug 26, 2013 - 9:12 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: October 27th, 2025 - 5:33 PM |