 cv axle, quick question. |
 Nov 3, 2013 - 10:10 AM
|
 
|
|
Enthusiast  Joined Jun 8, '13 From goldsboro, NC Currently Offline Reputation: 0 (0%)  |
How hard is it to change the driver side cv axle for some one that isn't too mechanicaly inclined.
|
 |
Replies
|
Nov 6, 2013 - 10:33 AM
|
|
|
Enthusiast Joined Jun 8, '13 From goldsboro, NC Currently Offline Reputation: 0 (0%) |
what about these ones on amazon?
http://www.amazon.com/TO87698768A-front-Le...ota+celica+1995 when changing the driver side do i also need to remove the passenger side axle also? is there anything i should change out while im down there? QUOTE (Spider77 @ Nov 5, 2013 - 1:58 PM)  If the most amount of maintenance you've done is brake pads, then............well. Let me put it this way, there are a few different methods. One (this applies to OEM) you "pop" it out using the collars/pry bar. Two, slide hammer/vice grips/whatever, mostly this will apply to aftermarket as the "collars" are missing, Three (my preferred method, in regards to 'most" aftermarket), ratchet strap to keep tension and pry bar. All in all, the driver side is not that bad. If the half-shaft is shot, just get it out by whatever means and replace it. what do you mean by "collar" |
Posts in this topic
cwong cv axle Nov 3, 2013 - 10:10 AM
Schwartz202 What's the most that you have done as far as r... Nov 3, 2013 - 3:54 PM
cwong QUOTE (Schwartz202 @ Nov 3, 2013 - 4... Nov 5, 2013 - 10:35 AM Schwartz202 QUOTE (cwong @ Nov 5, 2013 - 10:35 A... Nov 5, 2013 - 10:13 PM Tigawoods its a bit of a pain. the snap ring on the trans en... Nov 3, 2013 - 4:34 PM ILoveMySilly97 The snap ring is a pain in the ass. I tore apart m... Nov 3, 2013 - 6:52 PM RabidTRD QUOTE (ILoveMySilly97 @ Nov 3, 2013 - 6... Nov 3, 2013 - 9:18 PM Spider77 If the most amount of maintenance you've done ... Nov 5, 2013 - 12:58 PM cheela ok, so what are your guys' opinion/recommendat... Nov 5, 2013 - 2:39 PM mkernz22 autozone ones worked fine for me Nov 5, 2013 - 6:59 PM SwissFerdi QUOTE (cheela @ Nov 5, 2013 - 2:39 P... Nov 6, 2013 - 12:12 AM mkernz22 QUOTE (SwissFerdi @ Nov 6, 2013 - 12... Nov 6, 2013 - 10:04 PM SwissFerdi QUOTE (cwong @ Nov 6, 2013 - 10:33 A... Nov 6, 2013 - 5:28 PM Spider77 QUOTE (cwong @ Nov 6, 2013 - 10:33 A... Nov 7, 2013 - 6:51 PM ILoveMySilly97 Since you're down there you might as well buy ... Nov 6, 2013 - 4:59 PM Ted95 I just replaced a set again today, always a good t... Nov 7, 2013 - 12:58 AM ILoveMySilly97 ^The one I purchased refurbished drivers side from... Nov 7, 2013 - 8:50 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: October 25th, 2025 - 5:47 AM |