Nov 13, 2013 - 5:47 PM
|
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Mar 16, '09 From New York Currently Offline Reputation: 23 (100%) |
Hey so just now starting to get cold here (30-40 degrees F during morning starts). and my car is going nuts lol. its only on cold starts too, so maybe there is a fix, or someones had the problem.
Anyhow i have vids of whats happening on the cold start, and then like 3 mins later when it warms up just a tad and its fine. Only at idle as well, if i gas it even a little bit it just holds around 2k and doesn't jump. Maybe i can just tighten up the throttle cable a little for the winter months? It's fine when warm and driving too, no differences i can notice Cold start up vid ![]() Warmed up (fine) ![]() This post has been edited by mgnt232: Nov 13, 2013 - 5:48 PM -------------------- |
![]() |
Nov 14, 2013 - 4:43 PM
|
|
![]() Enthusiast ![]() ![]() Joined Nov 15, '10 From Austria Currently Offline Reputation: 1 (100%) |
Hi,
your engine is not warmed up fine, how high is the rpm once the temp. needle is in the middle of the scale? or after a drive of 10-15km? -> if it is around 1000rpm everything is fine...... you just have a little temp on the water but your oil is still cold greedz This post has been edited by Sunny: Nov 14, 2013 - 4:45 PM -------------------- |
Nov 14, 2013 - 5:02 PM
|
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Mar 16, '09 From New York Currently Offline Reputation: 23 (100%) |
no no confusion here sorry for that.
the second vid was just like 5 mins after the start up where the rpm's dropped slightly and it stopped going crazy. After its actually warm (operating temp) the oil pressure is around 30psi at idle and RPM around 800-900 at idle. This post has been edited by mgnt232: Nov 14, 2013 - 5:07 PM -------------------- |
mgnt232 Cold start 3rd gen 3sgte issue Nov 13, 2013 - 5:47 PM
lagos check your coolant temp sensor? Nov 13, 2013 - 8:15 PM
mgnt232 cough* where is that and how do i 'check' ... Nov 14, 2013 - 2:06 PM
mgnt232 bump? Nov 16, 2013 - 3:25 PM
malecrod Also Check the throttle cable and make sure its no... Nov 16, 2013 - 4:00 PM
mgnt232 the throttle cable isn't stuck. I took a look ... Nov 16, 2013 - 5:38 PM
presure2 looks to me like a large vac leak. the RPMS are re... Nov 17, 2013 - 11:11 AM
Hafkai The bouncing idle seems to be caused by the decele... Nov 17, 2013 - 4:54 PM
mgnt232 The second again video was only after 2 or 3 mins ... Nov 19, 2013 - 8:46 PM![]() ![]() |
| Lo-Fi Version | Time is now: October 25th, 2025 - 4:38 AM |