 Rev 3 3sge swap help, No crank |
 Dec 10, 2013 - 1:22 AM
|
 
|
|
Enthusiast  Joined May 23, '12 From northridge,CA Currently Offline Reputation: 3 (100%)  |
Hello I recently swapped over from 99 5sfe to 94-95 rev 3 3sge with e56 transmission,
My issue is that I can't get the car to crank from the ignition key, but I can start it from jumping the solenoid with the 12mm power on the starter. I can't seem to figure it out does anyone know of this problem and both 5sfe and 3sge were MT |
 |
Replies
|
Dec 10, 2013 - 2:50 AM
|
|
 Moderator Joined Nov 5, '07 From New Zealand Currently Offline Reputation: 3 (100%) |
I've messaged this guy a couple of times about this.
From what I understand the engine runs, but cannot start it the normal way via the starter, so my thought was its either the starter relay (Remember page 460 in the repair manual has info on how to check it.) Or the other thing I'm not too clued up on is the clutch starter since we never had that in our ST202/ST205's -------------------- |
Posts in this topic
mi645 Rev 3 3sge swap help Dec 10, 2013 - 1:22 AM
richee3 Kind of a silly question but I want to knock the e... Dec 10, 2013 - 2:26 AM njccmd2002 yeah, what did u do to the wiring of the car to sw... Dec 10, 2013 - 2:29 AM onnaj I would suspect the starter relay also. But best i... Dec 10, 2013 - 9:10 AM Batman722 At first take I would agree with Richee and Rusty.... Dec 10, 2013 - 11:17 AM KAOS What if the clutch starter pin/wire was possibly b... Dec 10, 2013 - 12:09 PM
mi645 Not 100% sure on my 5sfe but I had to normally pus... Dec 10, 2013 - 12:13 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: November 18th, 2025 - 11:58 AM |