 Rev 3 3sge swap help, No crank |
 Dec 10, 2013 - 1:22 AM
|
 
|
|
Enthusiast  Joined May 23, '12 From northridge,CA Currently Offline Reputation: 3 (100%)  |
Hello I recently swapped over from 99 5sfe to 94-95 rev 3 3sge with e56 transmission,
My issue is that I can't get the car to crank from the ignition key, but I can start it from jumping the solenoid with the 12mm power on the starter. I can't seem to figure it out does anyone know of this problem and both 5sfe and 3sge were MT |
 |
Replies
|
Dec 10, 2013 - 12:13 PM
|
|
|
Enthusiast Joined May 23, '12 From northridge,CA Currently Offline Reputation: 3 (100%) |
Not 100% sure on my 5sfe but I had to normally push in the clutch and turn it on, this motor I did not re pin anything for the clutch I didn't know we had to, I extended a few wires all I know is I need to rein the airbag I didn't know I need to repin starter cuz it already has a wife going to the relay and ea1 plug but if repin needs to be done which harness engine look or chassis?
|
Posts in this topic
mi645 Rev 3 3sge swap help Dec 10, 2013 - 1:22 AM
richee3 Kind of a silly question but I want to knock the e... Dec 10, 2013 - 2:26 AM njccmd2002 yeah, what did u do to the wiring of the car to sw... Dec 10, 2013 - 2:29 AM Rusty I've messaged this guy a couple of times about... Dec 10, 2013 - 2:50 AM onnaj I would suspect the starter relay also. But best i... Dec 10, 2013 - 9:10 AM Batman722 At first take I would agree with Richee and Rusty.... Dec 10, 2013 - 11:17 AM KAOS What if the clutch starter pin/wire was possibly b... Dec 10, 2013 - 12:09 PM
 |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: September 8th, 2025 - 12:05 PM |