 Can someone with a GT-Four hood take a few measurements? |
 Feb 13, 2014 - 8:05 AM
|
 
|
 Enthusiast  Joined Apr 12, '13 Currently Offline Reputation: 53 (100%)  |
Ok, I need these to measurements.
And if you can, how thick are the bolts that hold the plastic mesh piece. Inches, millimeters, doesn't matter, just be precise.  Thank you. |
 |
Replies
|
Feb 14, 2014 - 5:21 AM
|
|
|
Enthusiast Joined Apr 12, '13 Currently Offline Reputation: 53 (100%) |
QUOTE (Nial @ Feb 14, 2014 - 8:21 AM)  Depends which size you are looking for? The mesh has captive bolts attached to it. Athough 10mm is the spanner size to remove the nuts securing it in place, this is not the sizing of them, they are I think M6 nuts although knowing Toyota they are probably a metric fine...I finish work early today, I will measure them for you after lunch and report back. Do you want the size of the nut, or the size of the captive bolt? I want to know how thick it is, so I could figure out the radius of the holes they can go through. I'll be making a hood rain guard. Looking at Jeebus's picture the bolt is 5-6mm That's what I need.  Jeebus, thank you so much for taking the pictures and measurement. |
Posts in this topic
The_enD Can someone with a GT-Four hood take a few measurements? Feb 13, 2014 - 8:05 AM
Jeebus 10mm bolts. Feb 13, 2014 - 2:37 PM
The_enD QUOTE (Jeebus @ Feb 13, 2014 - 9:37 ... Feb 13, 2014 - 2:47 PM Jeebus Didnt get to take measurements as I was in a rush ... Feb 13, 2014 - 3:43 PM The_enD QUOTE (Jeebus @ Feb 13, 2014 - 10:43... Feb 13, 2014 - 5:06 PM Nial Depends which size you are looking for? The mesh h... Feb 14, 2014 - 1:21 AM Jeebus Here you go!
6 bolts: 3 on the top, 3 on the ... Feb 14, 2014 - 4:24 AM The_enD 10mm socket corresponds to 6mm bolt, just measured... Feb 14, 2014 - 7:43 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: December 6th, 2025 - 2:18 AM |