Highway Wonderland, Come on Catch Me If You Can Options

[Box]

Sammy Hagar references out of the way I figured I should do a project thread for my newly acquired Firebird. Since I already posted pictures in the Today I... thread I'll just post the one plus one of the engine for the time being.



For those that didn't see in the other thread it has a 4-bolt main 350 and TH-350 from a '69 Chevelle. The 350 has been bored .40 over, heads worked and shaved for 12:1 compression ratio, 3/4 cam, and Edelbrock 750cfm carburetor & intake. The transmission was also gone through and refreshed as well. The car also has new brakes and suspension, for whatever that's worth. Actually I'm surprised at how well it drives, sure it's no modern sports car but for a 70's muscle car I'm actually kind of impressed. Pretty much the bulk of what's needed is interior and exterior cosmetic work.

As far as plans I'd like to finish up the exterior and interior as I go. Then engine is sorted as far as I'm concerned, just needs some headers and a full exhaust done along with a new air cleaner setup as you can see. Oh, and hook up A/C again. I'll just get a compressor and brackets from a same year Camaro. Would like to upgrade the brakes and suspension along with converting to a manual one of these days. This will be a car I intend to keep for pretty much forever as I've always wanted one and it was/is one of my realistic dream cars, along with the Corvette. In the coming days I'll be touching up a few things here and there not really worth writing about, i.e. replacing bulbs and wipers etc... I'll have to get some exhaust videos this weekend when I have some time and help available. I think that pretty much covers everything. It does need some tires soon, so also trying to decide on what to do there. I can stay with 15's but get some snowflakes, get some 16's from the 3rd gen GTA, or get some 17's from Year One rather they be snowflakes or something else. I am heavily considering up-sizing to help with steering and handling feel, get ride of some of the sidewall flex...

[Box]

After revisiting some articles decided short/mid length headers will be best, as they give more power in the idle-4,000 rpm range where long tubes actually make considerably less power there and don't make more power over the shorties until the 4,200-6,000 range. Which considering I'll spend almost all of my time in the lower rpm's it makes more sense, plus they're a lot easier to install... Also based on calculations dual 2.5" should be more than enough. Probably will run some 30" MagnaPacks off each header and go out the side, that way don't have to worry about clearing the axle/paying a shop.