7afe to BEAMS Red Top Options

[Over9000]

Hi, new to the forum and can not find all the info I need for the swap I'm about to do. I have an AT200 and am swapping a beams redop in. My questions mainly have to do with Motor mount placement and wiring differences. I want to know how different the mounts are from a series to s, and how different the wiring set up will be. I have a full engine, tranny, engine harness, Ecu, all the pumps, axels, knuckles including the brake booster and master cyl( though I doubt I will need them) and suspension all around. More items, basically a front clip... Anyone actually do this type of swap and can let me know what the mount issue is and how much wiring I will be re-routing? Thanks

[Over9000]

Yeah, I read that article. Does explain some things regarding wiring, however I'm a little unclear of how much that thread applies to an At200... Am I the only one dumb enough to try this swap? Or does someone on here know what I'm about to go through. I specifically need info on where the s mounts are compared to my a series mounts, and if the rest of my harness will comply.

I'm going to need the gauge cluster for the Beams, and looking up the wiring for the swap isn't hard for me since I apprenticed at a Toyota and have some friends there. I would like to have this pass emissions though, so is there a piggyback or standalone Toyota drivers use to overcome this issue? Something similar to Hondata perhaps?