 Help!! Celica is runnig rich at idle, Celica is up and running today. |
 Aug 28, 2015 - 5:53 PM
|
 
|
 Enthusiast  Joined Jun 21, '14 From Ottawa, Ontario, Canada Currently Offline Reputation: 0 (0%)  |
Celica is up and running today. It's running super rich especially at idle. Any idea what may be the problem? My afr guage is buried at 10 and its burning black soot out the tail pipe.. It drives pretty good but it's jumpy when I let off the accelerator. I have a apexi neo safc installed. any links on how to set this up?
This post has been edited by doory100: Aug 28, 2015 - 7:03 PM -------------------- |
 |
Replies
|
Aug 28, 2015 - 7:40 PM
|
|
|
Enthusiast Joined Jun 21, '14 From Ottawa, Ontario, Canada Currently Offline Reputation: 0 (0%) |
yes the engine light is on. It was set to zero. but i turned the corrections off, It was still the same just idled abit lower with the corrections off. The gt celica is what sensor type. I think its a pressure sensor, is that correct?
-------------------- |
Posts in this topic
doory100 Help!! Celica is runnig rich at idle Aug 28, 2015 - 5:53 PM
Box Coolant temp sensor and primary O2 sensor are resp... Aug 28, 2015 - 7:12 PM doory100 is the primary o2 sensor, the one with the two bol... Aug 28, 2015 - 7:21 PM Bitter Is the engine light on? What's the AFC set to?... Aug 28, 2015 - 7:32 PM Bitter Yes, pressure sensor. What's the code set? Aug 28, 2015 - 8:01 PM doory100 Code set? Aug 28, 2015 - 8:02 PM Bitter The engine light, what's the code? Aug 28, 2015 - 8:05 PM doory100 Not sure I don't have a scanner on me. I'm... Aug 28, 2015 - 8:09 PM Bitter Don't guess, there could be a code set for the... Aug 28, 2015 - 9:28 PM doory100 I will look into that asap Aug 28, 2015 - 9:32 PM Box http://www.6gc.net/howto/determine_check_engine_li... Aug 28, 2015 - 9:59 PM doory100 Code: 25 and 31 Aug 29, 2015 - 7:28 AM Box 25 is air/fuel ratio lean and 31 is air flow meter... Aug 29, 2015 - 8:17 AM doory100 Ok I did the test where you clear the code and the... Aug 29, 2015 - 8:27 AM Bitter Whats your fuel pressure? Aug 29, 2015 - 10:20 AM doory100 I haven't checked the fuel pressure yet I have... Aug 29, 2015 - 10:36 AM Bitter Not that I'm aware of. What's the MAP sens... Aug 29, 2015 - 11:27 AM doory100 Wouldn't turning the corrections off on the sa... Aug 29, 2015 - 11:40 AM Bitter It should, unless there's something wrong or s... Aug 29, 2015 - 12:18 PM doory100 The settings are right and I hooked it up myself. ... Aug 29, 2015 - 1:08 PM Bitter It SHOULD be doing nothing at idle, AFC's are ... Aug 29, 2015 - 1:27 PM doory100 So their is two connectors on the Celica TB and th... Aug 29, 2015 - 3:04 PM Bitter Post a photo of the part in question. Aug 29, 2015 - 3:16 PM doory100 RE: Help!! Celica is runnig rich at idle Aug 29, 2015 - 3:31 PM Bitter That's the idle speed motor, it controls the i... Aug 29, 2015 - 3:32 PM doory100 So it would be okay if it wasn't plugged in be... Aug 29, 2015 - 3:36 PM Bitter Can you bolt on an original 5S throttle body and p... Aug 29, 2015 - 4:25 PM doory100 No, not with out removing the new intake manifold ... Aug 29, 2015 - 6:47 PM Bitter It sounds like the throttle body is the problem th... Aug 29, 2015 - 6:51 PM
doory100 QUOTE (Bitter @ Aug 29, 2015 - 7:51 ... Aug 29, 2015 - 6:53 PM Bitter Maybe, what's the MAP sensor reading at idle a... Aug 29, 2015 - 7:00 PM doory100 drove the car back to the shop today. I needed my ... Aug 29, 2015 - 7:10 PM Smaay wait a minute. what engine are you using and what... Aug 30, 2015 - 10:08 AM doory100 5sfe with a custom intake manifold and a 1mz v6 C... Aug 30, 2015 - 10:29 AM Bitter The MAP sensor is in the picture, top left on the ... Aug 30, 2015 - 10:33 AM doory100 Here is the new TB with the idle speed motor on it... Aug 30, 2015 - 11:53 AM Bitter That's the idle speed control motor and valve,... Aug 30, 2015 - 1:24 PM doory100 I am going to install the new TB today. I'm th... Aug 31, 2015 - 7:08 AM doory100 So installed the new TB and its still running rich... Aug 31, 2015 - 7:00 PM Bitter Uh you need the MAP connected to manifold vaccum, ... Aug 31, 2015 - 9:45 PM doory100 I have an idea. I just rebuilt a engine by myself ... Sep 1, 2015 - 5:04 AM doory100 so after putting the map vacume line into the TB, ... Sep 1, 2015 - 4:20 PM Bitter I'm not familiar with the Neo, I had a SAFC2 t... Sep 1, 2015 - 6:45 PM doory100 I used a T fitting like you said at the end of the... Sep 1, 2015 - 6:55 PM Bitter Ok, is the MAP sensor reading steady or does it do... Sep 1, 2015 - 6:58 PM doory100 Seems to be fine. Drives like it did before. Sep 1, 2015 - 7:40 PM Bitter You had the dead spot before too? Sep 1, 2015 - 8:11 PM doory100 No I'm not sure if it's still there I thin... Sep 1, 2015 - 8:25 PM doory100 blew the rad!! I hope I didn't damage ... Sep 5, 2015 - 6:51 AM doory100 Are there any other Toyota's that share the sa... Sep 5, 2015 - 6:20 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: August 28th, 2025 - 9:35 PM |