Turbocharging project from scrap Finished, Finish topic: TurboCharger project from Options

[west_minist]

The main post begins here, buy the full howto is a couple pages over.

http://www.6gc.net/forums/index.php?act=ST...&f=4&t=662&st=0


This howto is for any cylinder engine.

It have been tried on the 3SGE, 4AFE, 4AGE, 4AGE 20v Silver top, 4AGE 20v Black Top, Mazda 323's and a few other vehicles.

I still need to tweak it.

I need your input to further enhance this how-to

Copy of post below.

Again, all references should be made to the main post at http://www.6gc.net/forums/index.php?act=ST...&f=4&t=662&st=0.

I created this second post to get some 'light" from you.

Thanx

This post has been edited by west_minist: Feb 1, 2003 - 10:33 PM

[west_minist]

QUOTE (edo17982 @ Feb 6, 2003 - 5:08 PM)

There isn't a specific turbo kit for 7AFE....at JGS they give u what u need like manifold and Turbo... I've a question for you West.....if I'll add a turbocharger how I need to change CR, cams fases, lifts and valve angle/dimension?

I want to ask you one question edo17982?

you see what there offer. There just pull part together on one site for you. it may not be the best, but it is there.

Now tell me something, is my write up the same thing. I assume more than a 6g celica.

In other words, I try to help you make a decision than just some small kit.