 Axle seems stuck?, In-out play is reduced |
 Oct 22, 2016 - 3:50 PM
|
 
|
 Enthusiast  Joined Dec 26, '09 From Albuquerque, NM Currently Offline Reputation: 19 (100%)  |
So just finished installing the front LCAs with poly bushes and everything is going fine, until I try to reinstall the driver side upright. It seems like the in-and-out play of the axle is vastly reduced, like something is obstructing movement within the boot.
This issue is not letting me reinstall the upright because I cannot get it to reach the installation points. Either I bolt it to the strut knuckle and I can't swing it into the ball joint mount, or I bolt up the ball joint and I can't get it to the strut knuckle. The passenger side went in just fine. Any ideas? -------------------- taking too long to mod since '09
June '12 COTM '95 AT200 |
 |
Replies
|
Oct 24, 2016 - 1:26 PM
|
|
|
Enthusiast Joined Dec 26, '09 From Albuquerque, NM Currently Offline Reputation: 19 (100%) |
I've got the inner CV joint apart right now and everything looks healthy. Nothing broken and no blockages. YET the tripod still will not slide into the tulip!! There is nothing in the way...
If I can't figure this out soon, I may just buy a new LH axle. This is ridiculous. Each bearing is seated perfectly on the tripod, all snap rings are in place, and nothing is blocking the channels within the tulip. This is truly a mystery. -------------------- taking too long to mod since '09
June '12 COTM '95 AT200 |
Posts in this topic
HectortheRican Axle seems stuck? Oct 22, 2016 - 3:50 PM
HectortheRican Here's a picture of the driver side axle when ... Oct 22, 2016 - 5:03 PM slavie If you over-extended the outer joint and it slippe... Oct 22, 2016 - 7:57 PM
HectortheRican QUOTE (slavie @ Oct 22, 2016 - 6:57 ... Oct 22, 2016 - 8:35 PM slavie QUOTE (HectortheRican @ Oct 22, 2016 - 8... Oct 22, 2016 - 11:41 PM Bitter If the inner joint was over extended and it droppe... Oct 22, 2016 - 9:30 PM HectortheRican The same thing happened to my pass. side axle, but... Oct 24, 2016 - 12:59 PM slavie So what you're saying is that the axle will no... Oct 25, 2016 - 9:49 AM HectortheRican Yeah, unfortunately. I went out again today to cle... Oct 25, 2016 - 5:41 PM SwissFerdi Have you compared it side-by-side with the old axl... Oct 26, 2016 - 7:37 PM HectortheRican I tried one last time to try and get the **** thin... Oct 27, 2016 - 6:57 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: November 22nd, 2025 - 8:35 AM |