Distributor O-ring lubricant? Options

[Langing]

1994 Celica ST, 1.8L, Manual

Rebuilding the engine after 300,000 miles and an overheat incident. Need information that isn't in the BGB.

Trying to reassemble the IIA (distributor) into/on a 'remanufactured' head. The part of the assembly that goes into the head goes through a largish circular hole, and there is a large O-ring (distributor O-ring?) riding in a square cross-section groove cut into the IIA that supposedly seals the hole so oil does not escape from the head.

Some places I have read that the O-ring should be 'lubricated', but there is nothing about that in the Repair Manual (the big Green books). I had an unpleasant experience when I rebuilt the disk brakes a couple of years ago. Because of the 'lubricant' I used on the slider pins, the rubber ring absorbed something from the grease and made it swell such that the pins stopped sliding. Am I about to do something stupid again if I 'lubricate' this O-ring? And, what 'lubricant' or grease should be used to make that O-ring create a proper seal?

TIA

[Bitter]

If its in an engine on a distributor shaft then it's made for contact with oil so you can lube with whatever it's supposed to seal. Lube brake piston rings with brake fluid, lube, lube cooling system hoses and seals with coolant, lube engine o-rings with oil (except fuel system O-rings, lube them with...a sparing amount of silicone since silicone is bad for O2 sensors)