 K&N Cone Part Number, ST Cold Air Intake |
 May 25, 2004 - 11:11 AM
|
 
|
 Enthusiast  Joined May 10, '04 From Durham, NC Currently Offline Reputation: 0 (0%)  |
I went to pick up a K & N cone air filter for the how to posted here on the site for making a cold air intake for the Celica ST. I knew I needed a 2.5" inlet, but all of theirs were 3" or greater. They said they could order one, but needed the part number. Any of you that did the CAI, can you give me the filter's part number?
Thanks! |
 |
Replies
|
Jun 5, 2004 - 3:51 PM
|
|
 Enthusiast Joined Aug 28, '02 From B.C. Canada Currently Offline Reputation: 0 (0%) |
knfilters.com go there and pick out the style your looking for ie: stright or tapered and then find one with correct Mounting Flange Inside Diameter. Even if it's close to 2 1/2" you'll be fine it is rubber so it does stretch a bit and you can clamp it tight if it's a bit loose, I would't recomend going as big as 3" though. good luck!
|
Posts in this topic
keefer37 K&N Cone Part Number May 25, 2004 - 11:11 AM
KAMiX Sorry not sure, I used a 3". You can get 3... May 26, 2004 - 3:31 AM keefer37 One of the Web sites I was looking at the filters ... May 26, 2004 - 6:30 AM keefer37 Anyone know if that RX-4860 K&N cone filter ab... Jun 5, 2004 - 10:07 AM Drocay just get the one with the clamp, mine was 3 but i ... Jun 5, 2004 - 11:39 AM
Element23 i got the RX-4010, ordered it off of www.n2perform... Jun 5, 2004 - 3:54 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: April 2nd, 2026 - 10:58 PM |