![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() Joined May 23, '03 From Illinois Currently Offline Reputation: 0 (0%) ![]() |
I went to Merlins Muffler and Brake and got an estimate. They suggested cutting everything from the resonator back and making a 2.25" (stock is 1.75") exhaust system. It will cost $165 ($145 because i have a coupon). The price is without a muffler because I brought my own in (Flowmaster 40). Is this a reasonable price or if not where should I go? Meineke was too expensive. They were going to replace the pipe just before the muffler and it would cost $150.
Thanks This post has been edited by TRDDawg: Jul 1, 2004 - 2:14 PM |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Sep 28, '03 From Bloomington, IN Currently Offline Reputation: 0 (0%) ![]() |
From header back, my shop says 400 for mandrel bent stainless steel pipes. That's no cats or resinators.
Ok, some Qs. Sound I run a cat or resinator? I have a straight through muffler. And straight pipes on 4 cyl, usally sound awful. So should I just run one hi-flow cat, or what? What piping do I need? Some some know the measurements, so I can just order pipes off the internet? -------------------- NASA/SCCA RX-7....currently under the knife
92 Civic hatch B16 - Sold 10th anniv RX-7 - RIP The Slow Celica - Sold...and then crushed crushed due to street racing. Quote from Seinfeild: George's Boss reading a magazine: "People magazine's most beautiful people. Oh and a Celica...nothin wrong with that!" |
![]() ![]() |
Lo-Fi Version | Time is now: July 24th, 2025 - 5:31 PM |