![]() |
![]() |
![]() |
|
Enthusiast ![]() Joined May 3, '04 From Alhambra 62001 Currently Offline Reputation: 0 (0%) ![]() |
Ok so last month my serpentine belt started to go. So I went and got a new one. Since then I cannot not keep the belt tensioned and it will start to squell. I keep having to loosen the bold on the Alt and putting tension on the belt then tighten it done. Last week I ended up snapping the bolt and ran to the store to buy a new bolt. This week (today) it started to squell bad I made it a mile and it stoped, about 3 miles later my engine was smoking. Had to turn around and drive home only to find out the belt snapped in half, from the pully turning it and not turning the belt it burned it in half, and becouse my water pump and everything else was not turning the top of my radiour (sp?) blew off. Now when I replace the belt (again) what do I need to do to make sure it done not get loose, I mean I crack the heck out of the bolt and it does not last.
Im going to replace the radiour and all the pipes too! What a mess! Jason |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Feb 10, '03 From Connecticut Currently Offline Reputation: 11 (100%) ![]() |
Which bolt are u tightening? There should be 3. I have a 5sfe but the set up for the alternator should be the same. Theres one bolt for the bottom connecting the tensioner bracket to the block, one connecting the alternator to the rectangular piece with 2 holes tne the bracket, and finally the long screw which goes into the rectangular piece which tightens things up.
-------------------- |
![]() ![]() |
Lo-Fi Version | Time is now: July 25th, 2025 - 8:40 AM |