Adding Lines, Chassis to Door Options

[mr_dude]

So I'm doing a good quantity of interior LEDs and finally getting around to putting my power lock actuators in.

1. How have you all run your wiring ot the door? Just cut open the existing rubber tube and taped it back up?

2. I have to run 12 constant volts to the lock actuators. Where have you all put the actuators themselves, and gotten the 12v's?

[Coomer]

Are the little black boxes relays? Do they have four or five little prongs sticking out the bottom of them? I know I had to use two SPDT automotive relays to integrate my actuators in with the alarm. I wired them up like the following diagram shows.



And for sealing the doors again, you can use Silicon to hold that plastic on there.