Adding Lines, Chassis to Door Options

[mr_dude]

So I'm doing a good quantity of interior LEDs and finally getting around to putting my power lock actuators in.

1. How have you all run your wiring ot the door? Just cut open the existing rubber tube and taped it back up?

2. I have to run 12 constant volts to the lock actuators. Where have you all put the actuators themselves, and gotten the 12v's?

[mr_dude]

Relays, bingo. I only need one per door, I believe, because I have one lock/unlock button. Nice diagram, so many resources on this "internet."

Now for the actuators, one wire is lock and the other is unlock? Or is it hot/negative hot and ground?

Silicon eh? Does it come off as easy or create a semi-permanent seal?

Continuing thanks, I'll buy you a pint next time I find myself in Wa.