Adding Lines, Chassis to Door Options

[mr_dude]

So I'm doing a good quantity of interior LEDs and finally getting around to putting my power lock actuators in.

1. How have you all run your wiring ot the door? Just cut open the existing rubber tube and taped it back up?

2. I have to run 12 constant volts to the lock actuators. Where have you all put the actuators themselves, and gotten the 12v's?

[Coomer]

Yep, on the actuators, one wire is the unlock wire and the other is the lock wire. In the diagram above, the purple wire coming from the relay would get split and then would go to the lock wire for each actuator. The blue wire would get split as well, and would go to the unlock wire for each actuator. If you'd like some more in-depth knowledge on how exactly the relays work, I suggest reading up on some of the information on The12Volt.com, or just post and ask. There's a lot of helpful info there.