Limited edition side skirts for 6th gen, Limited edition side skirts for 6th gen Options

[NEVERSTOP]

I am going to produce a limited edition fiberglass side skirt for the 6th gen Celica.
It will be based off of the veilside/vis invader side skirt, but will have a air intake molded into the rear of it that will have the option of forcing air into the rear wheel well, thus cooling the rear brakes by cirrculating more air in the wheel well. The side skirts will come a with mesh grill insert that can be changed to match any other grills you may have. There will be a few other minor changes added.
These side skirts will be molded for a perfect fit... unlike the vis side skirt that need alot of modifications to fit correctly

Info:

Estimated cost: $350-400 for the set.
5 layer molded fiberglass.
Preped and primered.
Molded mounting brakets for mesh grill.
Mesh grill is included.
Tubing for funcional side skirts only.
Diagrams for cutting to fit tubing.
Hardware for mounting.
Approx weight: 5lbs each

Prototype designs will be availble soon.

These side skirts will be a limited edition only, I am planning on making ten sets and possibly more depending on demand.

I will NOT ship two sets within 300 mile of each other... That way they will be as close to one of a kind as possible. This way you won't drive down the street and see another Celica with these sideskirts.

I am also planning on developing a front and rear air dam for the 6th gen. I want to see how well the side skirts go over before I produce the front and rear.

I would like to have at least 10 sets preordered before I start to produce them. I do not need the cash up front. Money will be collected prior to shipping.

If you have questions or comments regarding this you can contact me via email.


Thanks
Neverstop
XNEVERSTOPX@aol.com

[NEVERSTOP]

To answer your question about sculpting.... Usally I would use streofoam or bent chicken wire to get a basic shape and then bondo and fiberglass for the details..

For this project I am actually using sculpting clay for the design.. Once it is all formed in the clay I will use a sealer on it and then make a fiberglass mold of it. Once I have a mold then I just use the mold to create the new pieces.

QUOTE

Everything looks great...as for buying it you can count me in (also known as 6th gen on celica.net). Although it'd take me a bit of time to get that kind of money, is that an issue?

Once I have the mold I can make these at any time... I am only really planning on making about 10 sets though... will make more if there is enuf demand for it but not sure how many people that say they want them will acutally pick them up.

Also I had hoped to have the drivers side done today but it snowed over the weekend and was too cold for me to work on it so I hope to have it done within this week.

Thanks
Neverstop