6G Celicas Forums

Welcome Guest ( Log In | Register )

> installing amp under front seat?
post Mar 11, 2003 - 11:00 PM
+Quote Post
robman5

Enthusiast
*
Joined Nov 3, '02
From mass
Currently Offline

Reputation: 0 (0%)




hey, anyone install their amp for subs in the back under the drivers seat?what did u have to do to mount it, where did u ground it, where did u run the power/rca cables and all that other **** and juicy detials, i need um its my first system install, well besides the headunit.thanks
 
Start new topic
Replies
post Mar 11, 2003 - 11:17 PM
+Quote Post
AudioFreak

Enthusiast
**
Joined Dec 19, '02
From West of Atlanta
Currently Offline

Reputation: 1 (100%)




Just threw mine under there today for the first time to check for clearance. I'm using a Soundstream refrence 500 and there is room but if the front seat isn't all the way back the amp shows. The fact that I never have anyone in back means this isn't a problem.

I'm gonna run the power cable down the left side of the car. Over the left wheel then into the car through a grommet in the drivers kick panel. There is plenty of room in the left door sill for wire. Ground the amp to one of the seat mounting bolts just clean off the paint first for a good ground. RCA's down the center consule.

Speaker wire can go down the left or right down the middle under the carpet. Choice is yours.

For mounting the amp I would use bolts with the bolt head on the bottom of the car. Plan where you will drill so you don't hit anything. Use washers under the nuts so you don't scratch the amp. Last step is to seal over the bolt heads to prevent it from rusting.

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: September 21st, 2025 - 1:02 PM