autometer c2 gauges not working. Options

[rjbibeau]

hi i'm running into some problems with installing my autometer c2 boost and A/F gauge. both are electronic gauges. first off the boost gauge is all wired and the map sensor is connected to the vacum line. when i turn the car on the gauge recalibrates itself meaning that is has the power source the stays on between acc and actually starting the car. but the gauge doesn't register the the vacum it just stays at zero. i'm not sure what is wrong.

with the A/F gauge there are three wires coming from it. o2 sensor wire which i have soddered to the 3rd pin on the top row on the 2nd clip from the left. and the white wire which is connected to my glow gauges so they turn on with my lights and the red wire which i have connected to the cigg lighter wire along with the boost gauge positive wire. but this is the odd thing the A/F gauge reads the o2 sensor reading only when the lights are off. when you turn the lights to parking the A/F reading light dimmens. and when you completely turn on the headlight the a/f gauge light won't show up the just turn off. anybody have any suggestions thank you
rick

This post has been edited by rjbibeau: Sep 27, 2004 - 11:49 PM

[rjbibeau]

the boost map sensor is hooked up right before and inline on the same hose as the stock map sesnor hose. and that hose leads to the intake manifold. i was thinking the same thing you were so i started the car and unhooked the vavum hose to the map sensor then the car started to idle low and then all of a sudden turned off. so there is vacum in the line so there aren't any leak somewhere.

so with the ignition switch what would i hook it up to then. it has to be something that stays on between acc and actually starting the car. i'm assuming the cigg lighter is like that right.....

This post has been edited by rjbibeau: Sep 28, 2004 - 3:09 PM