FS: 1995 Celica 3SGTE Project Car Options

[abatardi]

Hey guys,

Selling my long time project car and parts. Got a new car and trying to get rid of all this.

1995 Toyota Celica GT (silver)
3rd gen 3sgte swap with CT20B turbo
Engine rebuild about 4,000 miles ago with JE Pistons and Eagle rods.. all the goodies in the bottom end. 8.5:1 compression. All ARP hardware used everywhere...rods, head, flywheel. Broken in right with oil changed at 500, 1000, and 2500 miles.
3rd gen head wasn't touched.
Haltech E6K engine management
JDM (can't remember brand) 9lb flywheel
custom clutch by blacktrax performance out here in Bay Area, CA. Nice clutch. Copper/Kevlar setup. Bites hard.
um... front mount intercooler with some kind of ghetto looking aluminum pipes. Some hack did these for me as a temp job and i never got them fixed.
Blitz DD BOV
Supra TT fuel pump (the real one)
3 gauge pod pillar.
A couple autometer gauges.. boost and air / fuel
a couple picked through sets of st205 gaskets.
Exhaust is a full 3" from the turbo back with a blitz muffler. It's loud.
3" polished intake pipe with filter. I have an apex'i filter laying around somewhere too.

Have some uninstalled dropzone coilovers and some other little accessories like short shifter and crap. Also has 16" celica gt-s rims and kumho tires on it with a lot of use left.

Oh, and about 30 gallons of 103 octane if you want it.

Before the engine originally blew (hence the rebuild) it put down 227 ft lbs to the wheels. This was on a way-too-aggressive tune that had a lean spot that blew cylinder 2. It has since been retuned to run super rich but never leaned out and optimized yet.

The car is driveable...I use it to go to work some days. It has quite a bit of pick up to it.

Now the problems:
It sat in storage for over a year, then got shipped cross country. This was hard on it and there are some scraps on the fenders and the nose paint is chipping off. I was planning on repainting the entire thing once I had the cash.

The engine has never really run right.. It runs rich as all hell now and the idle sucks. It also doesn't like the cold. It idles very smooth in 90+ degree heat.

I think it just needs to be taken some time with and get on a dyno with a real tuner and get everything smoothed out. There could be a vacuum leak but I haven't been able to find it to date. Oh also everything is pretty dirty and could use a good through detailing.

Also got... a 95% complete st205 conversion for the body.

- st205 Hood
- st205 Nose
- most of the little grills and crap. I'm missing a couple seals and a grille i think for the nose. The hood and nose are pretty dirty and look worse than they are.
- st205 tails
- st205 headlights (projection, ALL 4)

The headlights and tails alone are worth a G. I'm looking to get a grand for all of the st205 parts + shipping or local pickup in Nor Cal. The headlights are mint and still in the original toyota boxes from japan. The tails are used. The hood has some standard small dings in it from shipping that get filled in when you paint it.

I'm looking for best offer on the car and all the acessories. I've literally got about $3k just in the engine rebuild for parts and labor.. not including the original cost of an ST205 engine. the haltech is another grand or so and all the other little parts add up quickly as you know. I'm only really looking to get back about a third of what I've spent on this car. This is about 5-6 grand, but any offers considered.

Shipping is pretty cheap now-a-days.. I think this would run around $750 hub to hub depending on where you live to ship the car. The st205 stuff not sure how much to ship.

I honestly think with a couple grand in work and some time and some paint and someone could have a very nice car out of this. I unfortunately work for one of the few internet companies in silicon valley that's still around and have no time. I also just bought a new car to have something reliable and don't want it just sitting around anymore like it has the last couple months.

I will have to find some time to take pictures of everything if anyone's interested. Any more questions, please don't hesitate to email me at ahastings@gmail.com

- Aaron

[ghostdog]

bump. got my shifter today, abatardi is a good seller