My Fiber glass sub box, Molded to the side Options

[creis]

Ok it’s been a long time since I started this project but its now just coming to an end with complete success. My holiday free time has proven to be just what I needed.

Anyway it’s a fiberglass duel 10" subwoofer box for my Audiobahn AW102T subs. (powered by my Audiobahn A8002T amp.) It’s molded to fit right up against the driver side just under the strut mount door and trunk light. It’s not molded into the side (there is a noticeable line/gap between the edges so that it’s removable if needed, however its maid so that the spare tire can easily be taken out without moving the box.

Below are some pic's showing its creation:

^My old box^






(It was pitch black when i took the pics, so they came out terrible)




^Used chrome looms and T joints to hide all the off color wires and electrical tape.^ The pic makes it look like there sitting on the floor but there actualy atleast 1/2 foot up untill after the inside sub where it angels and go right into the corner.

also: I still plan to make a fiberglass replacement for the trunk cover where I will mount the amp and cap to the trunk side covering them also with fiverglass (except for a few holes for the knobs etc.)

What do you guys think, Original? Anything I can add? I'm always open to new ideas!

This post has been edited by creis: Dec 28, 2004 - 5:38 PM

[DamDirtyApes]

would adding tinfoil in be a good idea? and to get the gliass to stay in place whats a good idea, jacking up opposite side of car and keeping th ecar on an anglea. if u feel this is hijacking ill edit my posts and make a new thread lol