 tap size, npt 1/8" |
 Jan 11, 2005 - 3:53 PM
|
 
|
 Enthusiast  Joined Sep 6, '04 From oakdale Mn Currently Offline Reputation: 0 (0%)  |
i can't find the right drill bit size for the 1/8" npt anywhere. i checked the interent and found some charts and every single chart the i found has got either an R or a C for some reason. what the heck is up with that??? does anyone know the right size drill bit to use??
--------------------  |
 |
Replies
|
Jan 14, 2005 - 3:51 PM
|
|
|
Enthusiast Joined Sep 6, '04 From oakdale Mn Currently Offline Reputation: 0 (0%) |
ya i know of the bsp thread. i think we have 1/8" bsp thread for our oil pressure sender unit. i took a 1/8" npt tap set at work it comes with a drill bit as wells as the tap and it doesn't say what size it is on the drill bit so i got the drill bit card thingy to measure diameter holes and the drill bit was a lil small in the 5/16" hole but i'm sure it would work becuase it tapers off. thanks for your help man
-------------------- |
Posts in this topic
rjbibeau tap size Jan 11, 2005 - 3:53 PM
rjbibeau bump it up Jan 12, 2005 - 1:57 PM wind since i work on a manufacturing floor and re-work ... Jan 12, 2005 - 2:41 PM rjbibeau ahh good info man i appreciate it. i gotta go buy ... Jan 12, 2005 - 2:45 PM rjbibeau here's my flanges custom made by mua Jan 12, 2005 - 2:58 PM rjbibeau what do you guys think of em? Jan 12, 2005 - 6:30 PM presure2 id say nice try..but a little on the crude side.. Jan 12, 2005 - 6:57 PM rjbibeau man i did that with an angle grinder give me some ... Jan 12, 2005 - 11:14 PM 97GTinKC My tap set calls for an 11/32 drill bit for 1/8-27... Jan 14, 2005 - 2:17 PM
rjbibeau i just tapped a 1/8" npt hole and the threads... Jan 23, 2005 - 5:16 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: September 13th, 2025 - 7:58 AM |