i need to replace my valve seals, has anyone done this firsthand?? Options

[forkee]

k so i thought it was my turbo's fault the first time i was burning oil cuz when i took it off and ran stock, i didnt get any smoke. after getting the turbo rebuilt, it fixed the oil leak problem, but it was smoking again. turns out the added pressure is letting oil get past the seals onto the stems and burning out the back. and its really bad too. i added some "no smoke + stop leak" stuff, and it helps on the low end, but when i really punch it, i still get A LOT of smoke. i mean it clears the freeway about 50 feet behind me.

so my question is, has anyone replaced theirs or gotten it replaced?? i need to get this done asap because its really starting to bug me. plus its deterring me from boosting because i can never go full throttle. if anyone has had this done, how much did it cost for either DIY or for a mechanic to do it, what parts will i need, and where can i find those parts.

thank you

[playr158]

ok forkee go to advanced auto trash go to the rice section aka the neons and such look for a lil filter it will say breather

no go into your engine back and disconnect the line between your vavle cover and intake manifold

put the breather on the vavle cover side and cap off the intake vavle side with a rubber cover