GB: CF License Plate Holders, (Part the License Plate goes on) Options

[Consynx]

I'm going to make a sample picture later tonight, but here's one DoGGy made in the CF Hatch Thread.

These will cost roughly $200, and the method of how they will be made is still to be determined.
it will be about $200 if they are pure CF, but cheaper if they are fiberglass molds w/ CF overlay...

I will give a definate price later in time, but expect to pay about $200


This is just an interest thread
and I shall start the list:

1) ConSynX

[Digndoug]

Could I ask whats the point. I can understand if its what I made. but just a replacement thats going to add more wieght?? Im lost. oh here is what I made and was trying to get peps intrested in awhile ago.

[My94RedCelica]

Could I ask whats the point. I can understand if its what I made. but just a replacement thats going to add more wieght?? Im lost.  oh here is what I made and was trying to get peps intrested in awhile ago.


[right][snapback]237668[/snapback][/right]

The point for me is that it will give me an advantage at car shows. If our carbon fiber trunk goes through, it will pull the back end together. Carbon fiber is my theme, inside and out. So the more carbon fiber products made for my car, the more emphasized my theme is. While the filled in plate is unique, it's not at all the style I'm looking for.