![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() Joined Jan 8, '05 From Alabama Currently Offline Reputation: 0 (0%) ![]() |
I have the ****ty ST...i can't afford a 3sge or 3sgte, its too much cash to do the swap and the tranny and the wiring is hard so instead I want to go with an easier route....i know most people with the 7afe put the 20v 4age head on and they end up with a 7age but they get low revv and only gained hp in the 5k range...is it better the just switch out the whole engine with a blacktop 4age to ur st tranny giving u 165 at the crank? and is it possible to turbo charge this in the future? Other get the 4agze but it only pushes 165 in the low end so isnt it better to have a black top with same hp and without the supercharger...i just dont know what to do...i need a reliable engine cuz my 7afe is bout to die...
|
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() Joined Nov 15, '02 From Vidor, TX Currently Offline Reputation: 1 (100%) ![]() |
well you can pick up a 4agze engine for 900 max on ebay, the harness i knwo a place that will make it for you for 450 and the labor thats the easy part... if you where in cali i could do it for 400 labor...
-DMC |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Dec 27, '03 From Nor Cal Currently Offline Reputation: 0 (0%) ![]() |
Gotta consider shipping when you're buying from ebay... and there is very very little protection if you get a bad engine. That will only cost more money. And being a "swapped" guy DMC... you should also know basic labor such as gaskets, belts, seals, clutch, water pump, etc... should also be done because of the relatively unknown conditions of used engines. That itself can be costly. No-one ever really mentions anything about that step... and I hope it's being done.
Take it from me... basic engine replacement in a AE86 corolla gts... engine costed 300.00 out the door, was totally refreshed with all new seals and gaskets for about 100.00, another 100.00 for a clutch kit, 40.00 for a waterpump, basic tune-up stuff for 80.00, totalling a little over 600.00. That's just to prep the engine. If you cannot do the swap yourself... add in another 4-5 hours of labor at 60-100 dollars per hour depending on locale and shop just to drop in the engine... and then who knows how much for wiring... anywhere from 400-1000 dollars and trust me... you'll find you need stuff that you're not gonna have and then you'll have to buy it, order it, wait, and pay more money. -------------------- "It's ok to be naked girl... I'm an artist!"
1995 AT200 Celica ST: stocked out daily driver... 1984 AE86 Corolla GT-SR5: silvertop 20V 4AGE project car jacked up with goodies... 1991 SW2x MR2 n/a: bare bones hardtop model soon to be... |
![]() ![]() |
Lo-Fi Version | Time is now: July 20th, 2025 - 5:32 PM |