GT4 hood, fill gap between bumper and hood, Possible to mold bumper to fill the gap? Options

[dannesweden]

Im very interested in getting a GT4 hood, but I don't want that gap when using a bumper for the ST202. And I don't like the GT4 front bumper....

So I wonder if it's possible to mold the bumper (raise it a bit in the middle) and let the two lines from the hood continue down towards the bumper?
I hope you understand what I mean.

Have anybody done this? If you have please post pics.
Do I need anything else except the hood to make it work on a ST202? Anything inside to pop the hood?

//Danne

[dannesweden]

Thanks a lot guys, I really appreciate it.
If I understand the things right:
* Neverstops upper part of the bumper was a stock bumper (polyurethane i think), and therefore he could cut the bumper and bend it to the same level as the hood. And then fiberglass it on the side.

* Seans car with the veilside (probably fiberglass) couldnt be bended because if you do the fiberglass would brake, right? So he had to mold it with some material that I don't recognize, to get it in the right height.

//Danne

This post has been edited by dannesweden: Feb 17, 2005 - 5:17 PM